This paper attempts to theoretically establish the technical possibility of manually controlling the tunnelling probability of phonons through potential barrier by superimposing Ultra High Frequency (UHF) acoustic wave over the source of phonons transmission, which results into Acoustically Augmented Phonons (AAP). Tuneable high fidelity acoustic piezoelectric transducer emitters may be used to tune the tunnelling. If the probability of reflectivity of phonon (P) during tunnelling through the potential barrier is given by P(R)p and that of Acoustically Augmented Phonons(AAP) is P(R)AAP then it is analytically obtained that P(R)AAP = ∝ P(R)P . Where ∝ is dimensionless number and is defined as the augmentation factor which is dependent on structure based damping coefficient, wave number of superimposed UHF acoustic wave and phonon's kinetic energy. Enhancement of tunnelling probability by mechanically superimposing UHF acoustic wave over the in situ phonons is independent of initial UHF acoustic wave's amplitude. It is noted that the range of 'tunnelling enhancement AAP's wave numbers' (or frequencies) gradually broadens with increase in the kinetic energy of phonons and also gradually tends to a limit. Thus, existence of almost zero reflectivity of tunnelling probability through the potential barrier by Acoustically Augmented Phonons (AAP) is theoretically obtained. A general observation is that to achieve very low reflectivity of phonon tunnelling probability 'structural damping factor' must be small enough than superimposed UHF of acoustic wave number.
19 November 2020 in Journal of the Korean Physical Society
In this research, the optimization of the tunneling probability through a potential barrier by superimposing ultra high frequency (UHF) acoustic wave over the source of the incoming particle wave function was examined theoretically and was shown to result in acoustically augmented phonons (AAP). The graph of the tunneling probability against the kinetic energy fraction [(E/V0)= x] of the particle shows a line of inflection at a non-dimensionalized critical height yc ≈ 3.12879, where yc is universal tunneling constant (UTC). As the barrier height (y) is increased further (y > yc), the reflection increases, and the tunneling probability sharply declines, in general. The lowest possible value of y is guided by the inherent particle kinetic energy, the superimposed wave number n and the material parameter β. The’ gradient of the increase in probability’ rises with a drop in the wave number n and is larger at higher values of y. A higher ratio (E/V0) coupled with a permissible-smaller wave number (n) of the applied UHF acoustic wave, leads to a higher tunneling probability. For increasing values of the UHF wave numbers and decreasing x-values, the potential barrier becomes increasingly opaque to tunneling. The higher the value of y is, the higher the tunneling opacity of the potential barrier becomes. The tunneling probability is highest (=0.98673) at y = 4, x = 0.9, when the orders of β and k are comparable.
This paper is a new attempt to evaluate hail storm severity and hail suppression effects. In this paper a new concept of Quadratic Growth Hypothesis (QGH) has been proposed and examined in the prediction of hailstorm. Another new concept of Reaction Time (RT) has been presented which is useful for effective seeding in hail mitigation campaigns. Given complex nature of cumulus growth, rate of growth of cumulus (r) have been broadly categorized as Slow (r ? 0.2 dBZ/min), Moderate (0.2 < r < 0.8 dBZ/min) and Fast (r? 0.8 dBZ/min). Often cumulus shows reverse growth too. It is found that QGH based predictions are 100% correct for Slow growing cumulus and 62.5% accurate for Moderate. However, QGH predictions are incorrect when the cumulus growth reverses or when it is Fast. Empirically a “QGH-Rectangle” has been identified wherein QGH is precisely valid. Prediction skill scores [= (Correct prediction/Total Predictions made)] of 0.79, 0.79 and 0.75 are obtained from scan intervals of 10, 12 and 19 minutes data, respectively. Amongst the three data sets, 10 minutes scan interval is operationally safer for RT computation during hail mitigation campaigns. In most of the cases RT may range from 17.3 to 29.6 minutes. Maximum RT of 43 minutes is also noted for slow growing cumulus. Linear Extrapolation (LE) has been used to predict the cumulus motion speed which has been observed from 5 m/s to as high as 19.3 m/s. It is noted that larger scan interval of DWR data would exhibit more consistent and reliable speed prediction by LE method.