19 June 2003 in Journal of Tribology
The lubrication by thin film has become a very important role in micro machine, magnetic storage device and so on. As the thickness of lubricant film becomes thinner to several nanometers, the conventional law of lubrication becomes unable to use. Nonequilibrium molecular dynamics simulation (NEMD) was carried out to investigate the dynamic behavior of thin lubricant film confined between walls. The model used in these simulations is composed of two solid walls and fluorocarbon polymer lubricant. One of the walls is supporting a load and at the same time moving at constant velocity. Results indicate that the frictional behavior of confined lubricant varied with load; velocity field in the film retain liquid like structure under low load conditions, on the other hand, under high load conditions lubricant film becomes solidified and periodical stick and slip motion is observed at the layer near the wall. At the same time periodically vibrating friction force is observed. In this case, radius of gyration of lubricant molecules also changes periodically. It is concluded that the periodical vibration of friction force is caused by stick-slip with molecular deformation.
1 October 2007 in Tribology International
31 August 2016 in Tribology Letters
Adhesion force is among the most influencing factors in micro- and nano-mechanics. A liquid bridge between two bodies gives rise to the adhesion force, which usually acts as additional normal load. However, the adhesion force acts also in lateral. We measured the lateral adhesion force of a sheared liquid bridge between parallel plates. In addition, movement of contact lines is tracked by using an image processing technique, which allowed us to introduce an effective shear displacement. The lateral adhesion force has a linear relation with the effective shear displacement. It shows good agreement between experimental result and the analytical approach regarding changes of interfacial energy with simple rectangular shape of the liquid bridge. We further revealed that there is no contact line in pinned state even in the case with the very beginning of the sheared process. In this regard, however, the contact line on rougher surface is awkward in its movement. Therefore, the liquid bridge between two rougher surfaces has higher effective shear displacement, and it results in the higher lateral adhesion force.
1 March 2009 in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
In recent years, there have been advances in techniques for improving sliding performance by using coated films possessing superior tribological properties to reduce failure of mechanical elements. Those techniques are often used under severe conditions, such as elastohydrodynamic lubrication (EHL). In this paper, to devise the optimum design of a coated film with an interlayer, the stresses generated in such a coated film are analysed by using a three-dimensional numerical analysis method, and the strength of the film is evaluated numerically. As a result, it is shown that, when the ratio of the modulus of elasticity of the coated film, Ec, to that of the substrate, Es, is 0.50, it is preferable that the thicknesses of the coated film and the interlayer be larger, and that the modulus of elasticity of the interlayer range from that of the coated film to that of the substrate. Furthermore, it is shown that in the case of Ec/ Es=2.00, it is preferable to have a thicker interlayer irrespective of the values of the moduli of elasticity of the coated film and the interlayer.
6 January 2009 in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
The Young's moduli and wear characteristics of two cermet coatings were evaluated under normal atmosphere. The tested coatings were WC/12 per cent Co and Cr3C2/25 per cent NiCr made by using high-velocity oxygen fuel spraying. The Young's moduli of the coatings were obtained using cantilever bend tests. The wear characteristics were evaluated on a wear test apparatus. The WC/12 per cent Co was superior to Cr3C2/25 per cent NiCr in view of wear resistance. The Cr3C2/25 per cent NiCr coating exhibited low friction at higher temperature. A relation was found between the Young's modulus, hardness, wear resistance, and the offensiveness to the mating material of the tested coatings.