Luiz Carlos Rolim Lopes

Luiz Carlos Rolim Lopes

Auto-generated profile, based on publicly available information

Luiz Carlos Rolim Lopes

Universidade Federal Fluminense

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 December 2020 in Research, Society and Development
Verified
Journal Article
Open access
PDF file
GPGeraldine Nancy Rodriguez Perea
Geraldine Nancy Rodriguez Perea
MSMariana Bianchini Silva
Mariana Bianchini Silva
BFBruno Xavier de Freitas
Bruno Xavier de Freitas
ÉSÉsoly Madeleine Bento dos Santos
Ésoly Madeleine Bento dos Santos
LLLuiz Carlos Rolim Lopes
Luiz Carlos Rolim Lopes
Claudinei dos SantosClaudinei dos Santos
Claudinei dos Santos
Non-stoichiometric hydroxyapatite (HAp) presents an additional phase in its structure due to calcium or phosphorus excess, which can influence the material’s mechanical properties, as well as its bioactivity and biodegradability. While stoichiometric HAp, with calcium to phosphorus ratio (Ca/P) of 1.67, has been widely investigated, only a few studies have reported the synthesis of HAp with higher Ca/P ratio. In this work, non-stoichiometric HAp nanoparticles were synthesized using chemical precipitation method followed by a calcination protocol. In order to achieve better process control with chemical precipitation, starch, a natural additive, was applied. Three types of starch were selected for comparison: nonionic starch (NS), soluble starch (SS), and cationic starch (CS). Infrared spectroscopy and chemical analysis results confirmed the non-stoichiometric profile of the synthesized HAp, with a 1.98 Ca/P ratio. X-ray diffraction (XRD) results showed that HAp and calcium oxide (CaO) crystalline phases were obtained and no residual starch was detected. Rietveld refinements confirmed that, for all three types of starch, the content of crystalline HAp was greater than 96.5% and the unit cell volume was not affected. Scanning electron microscopy (SEM) showed agglomeration of particles. Nanoparticle tracking analysis (NTA) results demonstrated that the use of SS produced the smallest particles (approximately 60nm).