The present work highlights an attempt of fabricating a nanocomposite by the addition of multi-walled carbon nanotubes (MWCNTs) as a third phase into flexible ZnO–poly(vinylidene fluoride) (ZnO–PVDF) composites. MWCNTs played a very important role in distributing ZnO fillers in the PVDF matrix more homogeneously and increased the connection capability. Enhancement of the piezoelectric phase, dielectric permittivity, ferroelectric polarization, energy storage density and mechanical energy harvesting performance of ZnO–PVDF composites after the addition of MWCNTs was confirmed from the respective characterization studies. The sensing capability was demonstrated by the generation of ∼22 V ac output voltage through the application of human finger tapping on 15 wt% ZnO and a 0.1 wt% MWCNT-loaded PVDF (15PZNT) based composite film. The rectified voltage from the fabricated 15PZNT film was used to charge a 10-μF capacitor up to ∼3 V which was used for the illumination of 30 commercial LEDs. The maximum power density from the film was found to be 21.41 μW cm−2 at 4 MΩ load resistance. The effect of the addition of MWCNTs was also verified by simulation using COMSOL Multiphysics software.
We study the dynamics of two ensembles of atoms (or equivalently, atomic clocks) coupled to a bad cavity and pumped incoherently by a Raman laser. Our main result is the nonequilibrium phase diagram for this experimental setup in terms of two parameters: detuning between the clocks and the repump rate. There are three main phases: a trivial steady state (phase I), where all atoms are maximally pumped, a nontrivial steady state corresponding to monochromatic superradiance (phase II), and amplitude-modulated superradiance (phase III). Phases I and II are fixed points of the mean-field dynamics, while in most of phase III stable attractors are limit cycles. Equations of motion possess an axial symmetry and a symmetry with respect to the interchange of the two clocks. Either one or both of these symmetries are spontaneously broken in various phases. The trivial steady state loses stability via a supercritical Hopf bifurcation bringing about a -symmetric limit cycle. The nontrivial steady state goes through a subcritical Hopf bifurcation responsible for coexistence of monochromatic and amplitude-modulated superradiance. Using Floquet analysis, we show that the -symmetric limit cycle eventually becomes unstable and gives rise to two -asymmetric limit cycles via a supercritical pitchfork bifurcation. Each of the above attractors has its own unique fingerprint in the power spectrum of the light radiated from the cavity. In particular, limit cycles in phase III emit frequency combs—series of equidistant peaks, where the symmetry of the frequency comb reflects the symmetry of the underlying limit cycle. For typical experimental parameters, the spacing between the peaks is several orders of magnitude smaller than the monochromatic superradiance frequency, making the lasing frequency highly tunable.
Multiferroic BiFeO3-based polymer composites and their suitable combinations by rationalization of polarization have been utilized to design an efficient piezo-tribo hybrid nanogenerator for real life energy harvesting and sensing applications.
Enhancement in the output performance of triboelectric nanogenerators by using different suitable techniques is of tremendous interest among researchers. Here, we propose an easy and cost-effective technique to improve the output performance of the rarely explored poly(vinylidene fluoride) (PVDF) based piezo-tribo hybrid nanogenerators. The space charge polarization of the PVDF based composites has been tuned here by forming a PVDF/0.5(Ba0.7Ca0.3)TiO3–0.5Ba(Ti0.8Zr0.2)O3 (BCZT)/Multi-Walled Carbon Nanotube (MWCNT) based ternary composite. Along with the improved piezoelectricity of PVDF–BCZT based binary composites, the addition of a third MWCNT phase has helped in significantly improving the space charge polarization. The ac conductivity is increased to 5.29 × 10−12 and 1.23 × 10−11 Ω−1 cm−1 for the binary and ternary composites, respectively, from a value of 7.64 × 10−13 Ω−1 cm−1 (at 1 kHz) for neat PVDF. This improved conducting pathway formed by the increased space charge polarization has supported the easy transportation of mobile charge carriers within the composite film and film to the electrode, which has augmented the overall output piezo-tribo hybrid energy harvesting performance of the device. An ultrahigh output power density of ∼150 μW/cm2 has been achieved for the said ternary system, which suppresses the value of output power density of the other similar kind of devices fabricated via a similar technique. The applicability of this device has been further demonstrated by using it in powering up small electronic devices and in different sensing and energy harvesting applications. Thus, the device, after further tuning of its dimension, may be applied as a power source in various low-power-consuming portable electronic systems and self-powered sensing devices.