Hsin-Shu Peng

Hsin-Shu Peng

Auto-generated profile, based on publicly available information

Hsin-Shu Peng

Mechanical and Computer-Aided Engineering, College of Engineering, Feng Chia University , Taichung , Taiwan

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2019
Verified
Conference Paper
Closed access
WCWei Huang Choong
Wei Huang Choong
HPHsin-Shu Peng
Hsin-Shu Peng
Powei HuangPowei Huang
Powei Huang
KLKai-Fu Liew
Kai-Fu Liew
WSWei-Jie Su
Wei-Jie Su
This study used the cavity-surface infrared rapid-heating method and tensile specimens (ASTM-D638) to test the fiber compatibility and tensile characteristics of long glass fiber reinforced PA66 (LGF-PA66) composites. The weldline molding experiment on the injected specimen was conducted using a double-gate. In addition, the integration of infrared heating and cavity pressure measurement were developed to achieve cavity-surface heating and observe the effect of with/without cavity-surf ace heating on weldline tensile strength variation and correlated pressure distribution near the weldline region. On the other hand, a vent -well was designed in the center position of the specimen (vent-well depths are 0.9 mm, 1.8 mm, and 3.6 mm), in order to discuss the effect of the two-melts on fiber and melt compatibility in the compatible process. The experimental results show that vent-well provides better weldline tensile strength; moreover, infrared heating cavity -surface also provides the better weldline tensile strength of LGF-PA66 composites molded parts. In addition, from SEM images and cavity pressure distributions, considering in presence or absence of vent-well design and cavity-surface heating, it provides better weldline tensile strength and interfaces compatibility between fiber and resin at weldline region during molding stage.

26 December 2025 in Journal of Polymer Engineering
Verified
Journal Article
Closed access
Powei HuangPowei Huang
Powei Huang
HPHsin-Shu Peng
Hsin-Shu Peng
HCHung-Wei Chen
Hung-Wei Chen
Gas-assisted injection molding (GAIM) introduces high-pressure gas into the mold cavity after molten plastic injection, creating a hollow structure that reduces material usage and improves warpage and cooling deformation, particularly in thick-walled parts. However, conventional GAIM typically employs nitrogen at around 15 °C, which often leads to condensation and pressure drops due to the temperature difference with the molten polymer. These issues result in unstable gas penetration, asymmetric hollow structures, reduced dimensional stability, and surface defects from insufficient gas support. To address these challenges, this study integrates a gas heating module into the GAIM process and systematically evaluates its effects using the short-shot method and spiral-flow specimens. Experimental results show that gas preheating reduces solid material usage by more than 6 % and achieves an average weight reduction above 20 %, attributed to slower cooling and enhanced hollow formation. Heated gas also decreases shrinkage variability by over 20 %, lowers the overall shrinkage rate by ∼5 %, and simultaneously reduces melt pressure by ∼10 % while stabilizing gas output by ∼15 %, thereby improving dimensional stability and process robustness. Furthermore, the hollow ratio is increased by 15–20 % and penetration length is extended by ∼20 %, resulting in more continuous, symmetric, and well-defined hollow structures.