As part of the Fire Lab at Missoula Experiments (FLAME) in 2006–2007, we examined hygroscopic properties of particles emitted from open combustion of 33 select biomass fuels. Measurements of humidification growth factors for subsaturated water relative humidity (RH) conditions were made with a hygroscopic tandem differential mobility analyzer (HTDMA) for dry particle sizes of 50, 100 and 250 nm. Results were then fit to a single-parameter model to obtain the hygroscopicity parameter, κ. Particles in freshly emitted biomass smoke exhibited a wide range of hygroscopicity (individual modes with 0<κ<1.0), spanning a range from the hygroscopicity of fresh diesel soot emissions to that of pure inorganic salts commonly found in the ambient aerosol. Smoke aerosols dominated by carbonaceous species typically had a unimodal growth factor with corresponding mean κ=0.1 (range of 0<κ<0.4). Those with a substantial inorganic mass fraction typically separated into less- and more-hygroscopic modes at high RH, the latter with mean κ=0.4 (range of 0.1<κ<1). The bimodal κ distributions were indicative of smoke chemical heterogeneity at a single particle size, whereas heterogeneity as a function of size was indicated by typically decreasing κ values with increasing dry particle diameters. Hygroscopicity varied strongly with biomass fuel type and, to a lesser extent, with combustion conditions. Among the most hygroscopic smokes were those from palmetto, rice straw, and sawgrass, while smoke particles from coniferous species such as spruces, firs, pines, and duffs were among the least hygroscopic. Overall, hygroscopicity decreased with increasing ratios of total carbon to inorganic ions as measured in PM2.5 filter samples. Despite aerosol heterogeneity, reconstructions of κ using PM2.5 bulk chemical composition data fell along a 1:1 line with measured ensemble κ values.
1 April 2000 in Tellus B: Chemical and Physical Meteorology
Closure experiments were completed to compare measured and modeled aerosol optical properties and their dependence on controlled relative humidity (RH) and wavelength of light. NaCl, (NH4)2SO4, and NH4NO3 aerosol particles with approximate geometric mass mean diameters of 0.2 μm and geometric standard deviations of 1.7 were tested as part of this study. High evaporative losses (up to 40%) were observed for NH4NO3 aerosol at this particle size range due to heating, and the results from these tests have been excluded from the closure analysis. Aerosol optical properties were measured with a RH-scanning nephelometry system (humidograph) and modeled with a Mie–Lorentz light scattering model. Particle size distributions were measured with a scanning differential mobility analyzer. Closure between the measured and modeled values of the total light scattering coefficient (σsp), backscatter ratio (b), and Ångström exponent (å) for dry (low RH) aerosols was achieved within 0.0%–5%, 4%–15%, and 3%–17%, respectively. The values of f(RH), hemispheric b, and å at 80% RH agreed within 2%–27%, 1%–27%, and 1%–28%, respectively. Correcting for nephelometer nonidealities, including a heating artifact, improved the agreement between the measured and predicted σsp values at RH = 80% from 35% to 13% for the TSI nephelometer at the maximum heating condition, and from 18% to 11% for the Radiance Research, Inc. (RR), nephelometer. Accurate quantification of the closure for these optical properties is important when establishing visibility standards, and assessing the progress toward meeting those standards, as well as reducing the uncertainties in estimating radiative forcing due to those aerosols.