14 November 2011 in Physical Review Letters
We describe a microwave photon counter based on the current-biased Josephson junction. The junction is tuned to absorb single microwave photons from the incident field, after which it tunnels into a classically observable voltage state. Using two such detectors, we have performed a microwave version of the Hanbury~Brown\char21{}Twiss experiment at 4~GHz and demonstrated a clear signature of photon bunching for a thermal source. The design is readily scalable to tens of parallelized junctions, a configuration that would allow number-resolved counting of microwave photons.
24 September 2012 in Physical Review B
We calculate the room-temperature thermoelectric properties of highly doped ultrathin silicon nanowires (SiNW) of square cross section (3~\ifmmode\times\else\texttimes\fi{}~3 to 8~\ifmmode\times\else\texttimes\fi{}~8 nm2) by solving the Boltzmann transport equations for electrons and phonons on an equal footing, using the ensemble Monte Carlo technique for each. We account for the two-dimensional confinement of both electrons and phonons and all the relevant scattering mechanisms, and present data for the dependence of electrical conductivity, the electronic and phononic thermal conductivities, the electronic and phonon-drag Seebeck coefficients, as well as the thermoelectric figure of merit (ZT) on the SiNW rms roughness and thickness. ZT in ultrascaled SiNWs does not increase as drastically with decreasing wire cross section as suggested by earlier studies. The reason is surface roughness, which (beneficially) degrades thermal conductivity, but also (adversely) degrades electrical conductivity and offsets the Seebeck coefficient enhancement that comes from confinement. Overall, room-temperature ZT of ultrathin SiNWs varies slowly with thickness, having a soft maximum of about 0.4 at the nanowire thickness of 4 nm.
19 December 2016 in Applied Physics Letters
Silicon-based metal-oxide-semiconductor quantum dots are prominent candidates for high-fidelity, manufacturable qubits. Due to silicon's band structure, additional low-energy states persist in these devices, presenting both challenges and opportunities. Although the physics governing these valley states has been the subject of intense study, quantitative agreement between experiment and theory remains elusive. Here, we present data from an experiment probing the valley states of quantum dot devices and develop a theory that is in quantitative agreement with both this and a recently reported experiment. Through sampling millions of realistic cases of interface roughness, our method provides evidence that the valley physics between the two samples is essentially the same.
24 October 2014 in Journal of Applied Physics
We simulate phonon transport in suspended graphene nanoribbons (GNRs) with real-space edges and experimentally relevant widths and lengths (from submicron to hundreds of microns). The full-dispersion phonon Monte Carlo simulation technique, which we describe in detail, involves a stochastic solution to the phonon Boltzmann transport equation with the relevant scattering mechanisms (edge, three-phonon, isotope, and grain boundary scattering) while accounting for the dispersion of all three acoustic phonon branches, calculated from the fourth-nearest-neighbor dynamical matrix. We accurately reproduce the results of several experimental measurements on pure and isotopically modified samples [S. Chen et al., ACS Nano 5, 321 (2011);S. Chen et al., Nature Mater. 11, 203 (2012); X. Xu et al., Nat. Commun. 5, 3689 (2014)]. We capture the ballistic-to-diffusive crossover in wide GNRs: room-temperature thermal conductivity increases with increasing length up to roughly 100 μm, where it saturates at a value of 5800 W/m K. This finding indicates that most experiments are carried out in the quasiballistic rather than the diffusive regime, and we calculate the diffusive upper-limit thermal conductivities up to 600 K. Furthermore, we demonstrate that calculations with isotropic dispersions overestimate the GNR thermal conductivity. Zigzag GNRs have higher thermal conductivity than same-size armchair GNRs, in agreement with atomistic calculations.
30 March 2015 in Applied Physics Letters
The ultralow thermal conductivity, κ, observed experimentally in intentionally roughened silicon nanowires (SiNWs) is reproduced in phonon Monte Carlo simulations with exponentially correlated real-space rough surfaces similar to measurement [J. Lim et al., Nano Lett. 12, 2475 (2012)]. Universal features of thermal transport are revealed by presenting κ as a function of the normalized geometric mean free path ; the diffusive (Casimir) limit corresponds to . κ vs is exponential at low-to-moderate roughness (high ), where internal scattering randomly interrupts phonon bouncing across the SiNW, and linear at high roughness (low ), where multiple scattering events at the same surface results in ultralow, amorphous-limit thermal conductivity.
14 March 2019 in Nanotechnology
Even as today’s most prominent spin-based qubit technologies are maturing in terms of capability and sophistication, there is growing interest in exploring alternate material platforms that may provide advantages, such as enhanced qubit control, longer coherence times, and improved extensibility. Recent advances in heterostructure material growth have opened new possibilities for employing hole spins in semiconductors for qubit applications. Undoped, strained Ge/SiGe quantum wells are promising candidate hosts for hole spin-based qubits due to their low disorder, large intrinsic spin–orbit coupling strength, and absence of valley states. Here, we use a simple one-layer gated device structure to demonstrate both a single quantum dot as well as coupling between two adjacent quantum dots. The hole effective mass in these undoped structures, m * ∼ 0.08 m 0 , is significantly lower than for electrons in Si/SiGe, pointing to the possibility of enhanced tunnel couplings in quantum dots and favorable qubit–qubit interactions in an industry-compatible semiconductor platform.