Marc Sirrenberg

Marc Sirrenberg

Auto-generated profile, based on publicly available information

Marc Sirrenberg

Institut für Werkstoffe Ruhr‐Universität Bochum Universitätsstr. 150 44801 Bochum Germany

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 March 2024 in Materials Science and Engineering: A
Verified
Journal Article
Open access
APAlireza B. Parsa
Alireza B. Parsa
MSM. Sirrenberg
M. Sirrenberg
DBDavid Bürger
David Bürger
MMM.J. Mills
M.J. Mills
ADAntonín Dlouhý
Antonín Dlouhý
GEG. Eggeler
G. Eggeler

19 June 2024 in Materials Science and Engineering: A
Verified
Journal Article
Open access
MSM. Sirrenberg
M. Sirrenberg
DBDavid Bürger
David Bürger
SGStefan Guth
Stefan Guth
TBT. Babinský
T. Babinský
PTPascal Thome
Pascal Thome
GEG. Eggeler
G. Eggeler

28 May 2024 in Advanced Engineering Materials
Verified
Journal Article
Open access
MSMarc Sirrenberg
Marc Sirrenberg
TBTomás Babinský
Tomás Babinský
DBDavid Bürger
David Bürger
SGStefan Guth
Stefan Guth
APAlireza B. Parsa
Alireza B. Parsa
GEGunther Eggeler
Gunther Eggeler
The present work takes a new look at the high temperature strength of single crystal (SX) Ni‐base superalloys. It compares high temperature constant strain rate (CSR) testing, creep testing, and out‐of‐phase thermomechanical fatigue (OP TMF) testing, which represent key characterization methods supporting alloy development and component design in SX material science and technology. The three types of tests are compared using the same SX alloy, working with precisely oriented ‐specimens and considering the same temperature range between 1023 and 1223 K, where climb controlled micro‐creep processes need to be considered. Nevertheless, the three types of tests provide different types of information. CSR testing at imposed strain rates of 3.3 × 10 −4 s −1 shows a yield stress anomaly (YSA) with a YSA stress peak at a temperature of 1073 K. This increase of strength with increasing temperature is not observed during constant load creep testing at much lower deformation rates around 10 −7 s −1 . Creep rates show a usual behavior and increase with increasing temperatures. During OP‐TMF loading, the temperature continuously increases/decreases in the compression/tension part of the mechanical strain‐controlled cycle (±0.5%). At the temperature, where the YSA peak stress temperature is observed, no peculiarities are observed. It is shown that OP‐TMF life is sensitive to surface quality, which is not the case in creep. A smaller number of cycles to failure is observed when reducing the heating rate in the compression/heating part of the mechanical strain‐controlled OP‐TMF cycle. The results are discussed on a microstructural basis, using results from scanning and transmission electron microscopy, and in light of previous work published in the literature.