Elaine Liu

Elaine Liu

Auto-generated profile, based on publicly available information

Elaine Liu

Technische Hochschule Ingolstadt, Institute for Innovative Mobility, Ingolstadt, 85049, Germany

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2019
Verified
Conference Paper
Closed access
AHAlexander Hanss
Alexander Hanss
ELE Liu
E Liu
MAMuhammad Rizwan Abdullah
Muhammad Rizwan Abdullah
GEGordon Elger
Gordon Elger
Transient thermal analysis (TTA) by experimental thermal impedance (Zth) measurements and data simulation by transient finite element (FE) simulation are suited to investigate the thermal path and mechanical integrity of electronic devices. After calibration, the FE model can be used for failure mode analysis. In this paper first a FE model for blue Flip Chip (FC) LEDs is set-up and calibrated to the experimental data. To reduce the ambiguity of the parameter identification within the calibration process caused by the relative large number of model parameters in a transient FE simulation several sets of experimental data are measured and simulated: the LED assembled on different substrates, i.e. an AlN ceramic and a standard Al-IMS board, and similar LEDs, i.e. same LED type but different sized light emitting area (1 mm 2 and 0.5 mm 2 ). The model is calibrated in the time domain using b(z), i.e. the logarithmic time derived of Zth(z= ln(t)). The least square residuum of simulated and experimental data is minimized. Different approaches of fitting are compared, i.e. fitting b(z), Zth(t) and the structure function, resulting in b(z) being a good option for the LED under investigation. The calibration is obtained by an optimizer in an automated workflow, i.e. using ANSYS coupled with optiSLang.After calibration the model is used to identify failures during accelerated stress test. An automatic TTA tester is used to detect changes of the Z th (t) during accelerated lifetime testing, e.g. temperature shock testing.By implementing failure into the calibrated model, e.g. cracks in the solder joint, delamination of the EPI from the redistribution layer and degradation of the dielectric layer of the Al-IMS, the calibrated model is fitted to the b(z) curves of the aged samples. The strength of the approach is demonstrated by extracting the quantitative changes of the physical parameters from the fitted model in an automatic way.

15 June 2026 in Ocean Engineering
Verified
Journal Article
Closed access
AMAbilyn McConnell
Abilyn McConnell
ELElaine Liu
Elaine Liu
BBBret Bosma
Bret Bosma
INYONG KIMINYONG KIM
INYONG KIM
RARaza Ali
Raza Ali
BRBryson Robertson
Bryson Robertson