A magnetic field sensor based on magnetoelectric effects in a ferrite-piezoelectric layered sample is proposed. Such sensors are passive, provide direct conversion of magnetic fields into an electrical signal, and allow measurements of both ac and dc magnetic fields. A multilayer sample of nickel zinc ferrite-lead zirconate titanate has been used to characterize the sensor response to ac and dc fields, field orientations, frequency, and temperature. The sample shows a linear response for dc fields up to a maximum of 1750 Oe. The sensor output is temperature independent over 273-337 K, but is dependent on frequency of the ac excitation field. Operating at electromechanical resonance for the element enhances the sensor sensitivity by an order of magnitude. For ac magnetic field sensors, the output varies linearly with amplitude
Resonance magnetoelectric (ME) effects due to bending oscillations have been investigated in bilayers of Ni and lead zirconate titanate (PZT). For nominal sample dimensions, such oscillations occur at a few kilohertz that are much smaller than radial or thickness acoustic modes and result in ME voltage coefficients of 1V∕cmOe for tangential magnetization. The mode frequencies can be controlled with proper choice for thicknesses of Ni and PZT. Theoretical estimates of mode frequencies are in very good agreement with the data. The resonator is potentially useful for realizing low-loss ME sensor networks for ac fields as low as 10μOe.
Nonlinear magnetoelectric (ME) effects have been investigated in a multilayer of nickel zinc ferrite and lead zirconate titanate. The ME voltage has been measured under ac magnetic field amplitudes of up to over the frequency range . Frequency doubling is observed for the ME voltage generated across the multilayer and Fourier analysis of shows harmonics of . As is increased or is decreased, the shape of is distorted and its magnitude decreases due to nonlinearity of the magnetostriction and the sample conductivity.
The composite ferroelectric/ferromagnetic ceramics were prepared by conventional solid-state sintering technique. The magnetic properties are consistent with the ratio of the magnetic phase present but ferroelectric properties are degraded due to a sufficiently high degree of conductivity in the ceramics. Magnetoelectric coupling was observed at a local level by means of the scanning probe microscopy (SPM). Piezoresponse and magnetic force modes of SPM were both utilized to assess strain-mediated magnetoelectric coupling between neighboring grains. The observed variation in the magnetic signal after the electrical poling with SPM was attested to the changes in the magnetic interactions and magnetic anisotropy leading to broadening of the magnetic domain wall.