Armin G. Aberle

Armin G. Aberle

Auto-generated profile, based on publicly available information

Armin G. Aberle

Centre for Photovoltaic Engineering, University of New South Wales, Sydney, NSW 2052, Australia

Research Focus & Metrics

Academic Career Length

33Years (1994-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 2007 in Solar Energy Materials and Solar Cells
Verified
Journal Article
Closed access
OBOlaf Berger
Olaf Berger
DIDaniel Inns
Daniel Inns
AAArmin G. Aberle
Armin G. Aberle

1 April 1995 in Journal of Applied Physics
Verified
Journal Article
Closed access
AAArmin G. Aberle
Armin G. Aberle
PAPietro P. Altermatt
Pietro P. Altermatt
GHGernot Heiser
Gernot Heiser
SRStephen J. Robinson
Stephen J. Robinson
AWAihua Wang
Aihua Wang
MGMartin A. Green
Martin A. Green
The ‘‘passivated emitter and rear locally diffused’’ (PERL) silicon solar cell structure presently demonstrates the highest terrestrial performance of any silicon-based solar cell. This paper presents a detailed investigation of the limiting loss mechanisms in PERL cells exhibiting independently confirmed 1-sun efficiencies of up to 23.0%. Optical, resistive, and recombinative losses are all analyzed under the full range of solar cell operating conditions with the aid of two-dimensional (2D) device simulations. The analysis is based on measurements of the reflectance, quantum efficiency, dark and illuminated current–voltage (I–V) characteristics, and properties of the Si–SiO2 interfaces employed on these cells for surface passivation. Through the use of the 2D simulations, particular attention has been paid to the magnitudes of the spatially resolved recombination losses in these cells. It is shown that approximately 50% of the recombination losses at the 1-sun maximum power point occur in the base of the cells, followed by recombination losses at the rear and front oxidized surfaces (25% and <25%, respectively). The relatively low fill factors of PERL cells are principally a result of resistive losses; however, the recombination behavior in the base and at the rear surface also contributes. This work predicts that the efficiency of 23% PERL cells could be increased by about 0.7% absolute if ohmic losses were eliminated, a further 1.1% absolute if there were no reflection losses at the nonmetallized front surface regions, about 2.0% by introducing ideal light trapping and eliminating shading losses due to the front metallization, and by about 3.7% absolute if the device had no defect-related recombination losses. New design rules for future efficiency improvements, evident from this analysis, are also presented.

16 November 2004 in Progress in Photovoltaics: Research and Applications
Verified
Journal Article
Closed access
PDF file
AAA. G. Aberle
A. G. Aberle
ASA. Straub
A. Straub
PWP. I. Widenborg
P. I. Widenborg
ASA. B. Sproul
A. B. Sproul
YHY. Huang
Y. Huang
PCP. Campbell
P. Campbell

1 September 2000 in Progress in Photovoltaics: Research and Applications
Verified
Journal Article
Closed access
PDF file
AAArmin G Aberle
Armin G Aberle

1 September 2000 in Progress in Photovoltaics: Research and Applications
Verified
Journal Article
Closed access
PDF file
AAArmin G Aberle
Armin G Aberle