19 June 2022 in Ocean Engineering
17 March 2023 in Journal of Applied Physics
In order to analyze the influence of a water medium on the forming process and penetration performance of a shaped charge jet, a comparative study was carried out on an underwater shaped charge jet (USCJ) and a shaped charge jet (SCJ) in air. The virtual mass hypothesis is proposed to analyze the forming mechanism of USCJs. The arbitrary Lagrangian–Eulerian algorithm is adopted to carry out a series of simulation calculations considering the impact of standoff height and liner cone angle. The penetration test of the shaped charge jet in two media is carried out, and the experimental results verify the effectiveness of the theory and simulation. The differences of SCJ formation and penetration in air and water are analyzed. The results demonstrate that the USCJ exhibits a higher jet head velocity, higher cumulative kinetic energy, and a greater penetration ability than those of the jet in air. The depth of penetration (DOP) initially increases and subsequently decreases with an increase in the standoff height. The optimal standoff height of the USCJ is approximately 4–4.5 times greater than the charge diameter, whereas the SCJ in air is approximately 3.5–4 times greater than the charge diameter. Additionally, the DOP of the jet decreases at the optimal standoff height with an increase in the cone angle.
2 September 2025 in Journal of Applied Physics
Underwater shaped charge jets are widely utilized due to their excellent penetration capabilities. However, investigating the formation and penetration mechanisms of shaped charge jets at different water depths remains a challenge due to experimental limitations. To study the influence of water depth on the formation and penetration characteristics of shaped charge jets, pressurized jet experiments simulating water depths from 0 to 400 m were conducted, and numerical simulations were performed to analyze the jet formation and penetration process at depths ranging from 400 to 6000 m. The results indicate that, for a given shaped charge configuration, the depth range of 0–600 m falls within the domain governed by the virtual mass principle. Between 600 and 1000 m, the region represents a transition zone. From 1000 to 6000 m, the jet enters a prestress-dominated zone, where hydrostatic pressure induces yield stress and plastic strain in the liner, thereby affecting the jet formation characteristics. Furthermore, variations in material properties increase the energy of shock waves acting on the liner, further influencing the jet formation process. This study provides guidance for the parameter design of underwater shaped charges.