The microstructural properties and hardness of a model ternary Fe-4Cr-6Ti ferritic alloy aged at 800°C for 8, 16 and 24 h are investigated in detail. Fine Fe2Ti Laves phase particles precipitate in the α-Fe (ferrite) matrix phase after solutionizing and subsequent aging treatments. The size and amount of Fe2Ti precipitates gradually increase with increasing aging time. The magnetic measurements of the aged samples confirm the variations in the microstructural properties including the volume fraction of the constituent phases, and Ti content of the α-Fe matrix phase. The mean Vickers microhardness value also increases from 203.5 to 238.4 with increasing aging time from 8 to 24 h. In addition, the cyclic oxidation behavior of 24 h aged sample, which contains maximum amount of Fe2Ti precipitates, is also investigated in detail. X-ray diffraction analysis reveals that scale product is α-Fe2O3 (hematite). Significant scale spallation and void formation is observed on the surfaces of 24 h aged Fe-4Cr-6Ti sample oxidized at 500°C.
19 July 2023 in International Journal of Metalcasting
The influence of Y addition on the microstructural features, phase relationships, hardness, magnetic behaviour and cyclic oxidation performance of Fe60Al40−nYn alloys (n = 1, 3, and 5 at.%) has been examined in detail. Al8Fe4Y phase formed even at 1 at.% Y addition because of the limited solid solubility of Y in the FeAl-based phase. For all the examined compositions, the Al8Fe4Y phase developed a eutectic with the FeAl-based phase and its volume fraction increased with increasing Y up to 5 at.%, which is near the eutectic composition. The mean microhardness values increased with increasing Y content for both as-cast and heat-treated samples. Cyclic oxidation tests revealed that the oxidation rate and scale thickness increased with increasing Y content. α-Al2O3 was the main surface oxide for all compositions. θ-Al2O3 was also formed with relatively low amount. An internal oxidation layer composed of mixed Al/Y oxides was observed beneath the surface layer.