1 July 2020 in IET Radar, Sonar & Navigation
This study presents the concept, design, and operation of a low‐cost and lightweight multiple‐input multiple‐output (MIMO) radar system, dedicated to the characterisation of complex volumetric environments such as snow, forest, sand etc. using synthetic aperture radar tomographic focusing. The system consists of six transmitting and six receiving antennas, operated in a multi‐static configuration, resulting in an equivalent mono‐static vertical virtual array. Antenna positions have been set considering a trade‐off between coupling effects, imaging ambiguities due to spectral folding and vertical resolution. The system also contains radio frequency signal generation and acquisition blocks and has been developed and operated at the IETR laboratory of the University of Rennes 1. An element‐orthogonal frequency division multiplexing technique is proposed that avoids the use of switches for selecting transmission and reception channels, using a specific carrier for each transmit channel, and spectral analysis of each receive channel, allowing the 36 MIMO channels to be retrieved. The use of a time‐domain back‐projection algorithm for imaging in the elevation direction provides results that confirm the potential of the system for the characterisation of complex media.
24 October 2024 in IEEE Geoscience and Remote Sensing Letters
The detection of multiple scatterers within each resolution cell is an open research subject in Synthetic Aperture Radar tomography. For over a decade, the Generalised Likelihood Ratio Test (GLRT) detector has been implemented along with its variants, allowing the generation of height maps and 3D point clouds with good precision. However, they are limited by the grid search during the optimization of the Maximum Likelihood function. In order to mitigate this, we propose a gridless version of GLRT where the Particle Swarm Optimization (PSO) method is used to locate the minima. The conducted analysis of the proposed detector with respect to the state-of-the-art methods behavior on simulated and real datasets proved the effectiveness of PSO-GLRT in terms of height accuracy and computational cost. The evaluation metrics Root Mean Square Error, Accuracy, and Completeness have been used as a quantitative improvement indicator for estimated height assessment.
30 May 2024 in IEEE Geoscience and Remote Sensing Letters
The reconstruction of high-elevation natural and artificial structures through Synthetic Aperture Radar (SAR) tomography has been an active research topic owing to its significance in various earth science applications. However, the complexity of this task arises from inaccuracies in the estimated reconstruction, attributed to factors such as low signal-to-noise ratios, decorrelations, few and uneven measurements, and overlapping scatterers. The utilization of iterative spectral estimation methods has been demonstrated to be beneficial in addressing some of these inaccuracies. Thus, selecting the best method within this class constitutes a challenge. In this context, our letter aims to propose a generalized formula linking the maximum likelihood-based iterative methods via a regularization parameter. The behavior of the latter is analyzed for several values in order to unveil the potential of the proposed approach in achieving a balance between noise reduction and detection performance. The experimental study has been conducted on simulated and real SAR data acquired by airborne and spaceborne systems covering tropical forest and build-up areas. The obtained results show the effectiveness and performance of the optimal regularization parameter to eliminate noise while preserving scatterers’ contribution.
10 July 2025 in IEEE Geoscience and Remote Sensing Letters
This letter deals with the estimation of the refractive index of snowpack based on particle swarm optimization (PSO) algorithm. By leveraging its ability to handle multidimensional optimization problems, PSO is used both to compute the shortest path between the synthetic aperture radar tomographic system antenna and the imaged snowpack scatterers, taking into account its permittivity and to optimize the difference in depth coordinates between the snowpack tomogram and a simulated one using the same system configuration and measurement parameters. The proposed method is applied on two measured tomogram, namely, those whose data were acquired during a measurement campaign carried out in the French Alps.
9 November 2025 in International Journal of Remote Sensing
27 April 2026 in IEEE Transactions on Geoscience and Remote Sensing
This paper presents a Generalized Iterative Sparse Maximum Likelihood Algorithm (GSMLA) for buried-target detection using Ground Penetrating Radar (GPR). The proposed approach extends the classical SMLA family (SMLA-0, SMLA-1, and SMLA-2) while addressing their individual limitations. Although SMLA-0 achieves strong sparsity and effectively suppresses smearing, it struggles to recover scatterers under low-SNR conditions. SMLA-1 improves detectability but remains affected by smearing, outliers, and limited resolution. SMLA-2 provides a more balanced trade-off, yet it cannot simultaneously preserve sparsity and high resolution while suppressing outliers and smearing artefacts. In contrast, GSMLA achieves sparse, high-resolution reconstructions with enhanced robustness to noise and improved suppression of outliers and smearing. An adaptive strategy is introduced to automatically select the regularization parameter α using negative log-likelihood evaluation, allowing GSMLA to self-adapt to different acquisition scenarios without manual tuning. Moreover, the proposed method incorporates a ray-tracing-based permittivity compensation, which accounts for the influence of the homogeneous medium on wave propagation, further improving the accuracy of scatterer localization. The effectiveness of GSMLA is demonstrated using both simulated and measured GPR data, where it consistently delivers superior imaging performance compared with existing SMLA variants.