The pumping and shooting of high performance wet-mix shotcrete usually involves a certain amount of compromise. On the one hand, engineers design a mixture with high workability for ease of transport through the hose, and on the other hand, they strive for a mixture that is relatively stiff, adhesive, and cohesive to achieve good adhesion and build-up on vertical or overhead shooting surfaces. Although a decade of developments in set accelerating admixtures and dosing equipment have greatly simplified the application of wet-mix shotcrete in underground environments, only a few fundamental or practical studies have been made on the pumpability of concrete. This paper presents some of the most recent research on the understanding of the key parameters affecting concrete mobility and stability under pressure, i.e. pumpability. Taking into account the mechanics of life-size pumping equipment, complete pressure profiles and pump cylinder fill-rates, along with rheological and tribological properties, are used to predict the mobility and pumpability of a given concrete mixture. A model that accounts for fluid properties and friction is also presented. Experimental results used to validate the model allow explanation of behavioral, variations between the different concrete mixtures.
1 January 2020 in Advances in Materials Science and Engineering
Early‐age cracking due to restrained shrinkage affects the performance and service life of concrete structures. Recent studies are successfully making use of the free ring shrinkage test in conjunction with restrained shrinkage measurements for the evaluation of the cracking potential of cementitious materials. This study provides information to improve the interpretation of cracking in ring specimens and a theoretical approach for predicting the stress rate of thick ring specimens. Results show that the rate of strain development and the age‐at‐cracking vary with specimen drying direction and the exchange surface‐to‐volume ratio. The results further revealed that early‐age shrinkage cracking depends more on the shrinkage rate than the magnitude of the shrinkage itself. Also, it was found that although the restrained ring specimens attained approximately similar strain levels, the cracking age varies significantly, suggesting that elastic stress‐strength analysis alone may be inadequate for predicting early‐age cracking due to the contribution of creep‐relaxation phenomena.
1 February 2017 in Revista IBRACON de Estruturas e Materiais
Over the last few years, comprehensive management programs for the diagnosis and prognosis of alkali-aggregate reaction (AAR) in aging concrete structures were developed in North America, based on a series of laboratory test procedures. Although promising, these lab-procedures presented several parameters whose impacts were not completely understood, which significantly reduced their applicability for the appraisal of deteriorated concrete structures in service. In this context, it has been suggested that two lab-tools, the Stiffness Damage Test (SDT) and the Damage Rating Index (DRI) could reliably assess the condition of concrete affected by AAR. This paper presents the condition assessment of 25, 35 and 45 MPa AAR affected concrete specimens incorporating fine and coarse reactive aggregates and presenting different distress degrees (i.e. expansion levels from 0.05 to 0.30%) through the use of an innovative multi-level approach. Results show that both SDT and DRI are suitable for assessing damage in AAR affected concrete through their output parameters. Yet, they present a complementary character, which illustrates the need for a multi-level approach.
19 December 2017 in Advances in Materials Science and Engineering
Although considerable progress has been made in enhancing the use and interpretation of free ring shrinkage test, little is known about the impact of the test procedure, the specimen geometry, the surface area-to-volume (S/V) ratio exposed to drying, and the boundary conditions (sealing configuration) on the measured shrinkage. This paper highlights recent findings illustrating the influence of the test procedure, the S/V ratio exposed to drying, the geometry of specimen, and the boundary conditions. A series of experimental results are presented from free shrinkage on ring test specimens to illustrate that the test procedure can significantly influence the measured free shrinkage. A second series of experimental results are presented from specimens with different geometries and S/V ratio exposed to drying to illustrate that drying shrinkage is dependent on both the specimen geometry and the surface exposed to drying. Test results further show that, even for the same S/V ratio exposed to drying, shrinkage is strongly dependent on the specimen’s geometry and boundary conditions.