Karlos Espinoza

Karlos Espinoza

Auto-generated profile, based on publicly available information

Karlos Espinoza

Universidad de Guadalajara

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2016 in Computers and Electronics in Agriculture
Verified
Journal Article
Closed access
KEKarlos Espinoza
Karlos Espinoza
Diego ValeraDiego Valera
Diego Valera
JTJosé A. Torres
José A. Torres
AMAlejandro López Martínez
Alejandro López Martínez
FMFrancisco Domingo Molina-Aiz
Francisco Domingo Molina-Aiz

1 December 2017 in Biosystems Engineering
Verified
Journal Article
Closed access
KEKarlos Espinoza
Karlos Espinoza
AMAlejandro López Martínez
Alejandro López Martínez
Diego ValeraDiego Valera
Diego Valera
FMFrancisco Domingo Molina-Aiz
Francisco Domingo Molina-Aiz
JTJosé A. Torres
José A. Torres
APAraceli Peña
Araceli Peña

12 August 2015 in Sensors
Verified
Journal Article
Open access
PDF file
KEKarlos Espinoza
Karlos Espinoza
Diego ValeraDiego Valera
Diego Valera
JAJosé Antonio Torres Arriaza
José Antonio Torres Arriaza
AMAlejandro López Martínez
Alejandro López Martínez
FMFrancisco Domingo Molina-Aiz
Francisco Domingo Molina-Aiz
Wind tunnels are a key experimental tool for the analysis of airflow parameters in many fields of application. Despite their great potential impact on agricultural research, few contributions have dealt with the development of automatic control systems for wind tunnels in the field of greenhouse technology. The objective of this paper is to present an automatic control system that provides precision and speed of measurement, as well as efficient data processing in low-speed wind tunnel experiments for greenhouse engineering applications. The system is based on an algorithm that identifies the system model and calculates the optimum PI controller. The validation of the system was performed on a cellulose evaporative cooling pad and on insect-proof screens to assess its response to perturbations. The control system provided an accuracy of <0.06 m·s‾1 for airflow speed and <0.50 Pa for pressure drop, thus permitting the reproducibility and standardization of the tests. The proposed control system also incorporates a fully-integrated software unit that manages the tests in terms of airflow speed and pressure drop set points.

1 November 2017 in Acta Horticulturae
Verified
Journal Article
Closed access
FMFrancisco Domingo Molina-Aiz
Francisco Domingo Molina-Aiz
Tomas NortonTomas Norton
Tomas Norton
AMAlejandro López Martínez
Alejandro López Martínez
ARA. Reyes-Rosas
A. Reyes-Rosas
MMM.A. Moreno
M.A. Moreno
Diego ValeraDiego Valera
Diego Valera
ISHS V International Symposium on Models for Plant Growth, Environment Control and Farming Management in Protected Cultivation (HortiModel2016) Using Computational Fluid Dynamics to analyse the CO2 transfer in naturally ventilated greenhouses

AMAlejandro López Martínez
Alejandro López Martínez
Diego ValeraDiego Valera
Diego Valera
FMFrancisco Domingo Molina-Aiz
Francisco Domingo Molina-Aiz
MMMaría De Los Ángeles Moreno
María De Los Ángeles Moreno
APAraceli Peña
Araceli Peña
KEKarlos Emmanuel Espinoza-Ramos
Karlos Emmanuel Espinoza-Ramos
The present work analyses the traditional method of applying whitening products on Mediterranean greenhouses. Four commercial whitening products (agricultural solar protectors, ASPs), applied at four doses, were compared with a non-whitened cover. The traditional product “Blanco de España” with 99% calcium carbonate (CaCO3) and other three products with 97% CaCO3 that incorporate adhesives were tested. The use of adhesives in ASP did not influence the effect of the different products on the inside temperature, and at the same dose all four products show a similar behaviour. The findings support the maximum dose recommended by other authors of 0.50 kg L−1 (50/100), above which the transmissivity of the greenhouse cover decreases by over 50%. The effect of ASP on the transmissivity of the cover depends principally on the dose applied, but also on the climatic conditions (solar radiation, cloud cover, etc.) and on the time of year (solar elevation). The habitual use of a constant dose throughout the year does not seem to be the most adequate. Recommended doses should vary according to the time of year and the desired degree of transmissivity reduction. The adhesive components are shown to provide a high degree of protection against heavy rain. The study recommends a standardised method of ASP application, establishing a method that allows the grower to verify the concentration of the product that will remain on the greenhouse cover.

10 November 2019 in Agronomy
Verified
Journal Article
Open access
PDF file
AMAlejandro López Martínez
Alejandro López Martínez
FMFrancisco Domingo Molina-Aiz
Francisco Domingo Molina-Aiz
Diego ValeraDiego Valera
Diego Valera
JLJavier Lopez
Javier Lopez
APAraceli Peña
Araceli Peña
KEKarlos E. Espinoza-Ramos
Karlos E. Espinoza-Ramos
The present work analyses the natural ventilation of a multi-span greenhouse with one roof vent and two side vents by means of sonic anemometry. Opening the roof vent to windward, one side vent to leeward, and the other side vents to windward (this last vent obstructed by another greenhouse), causes opposing thermal GT (m3 s−1) and wind effects Gw (m3 s−1), as outside air entering the greenhouse through the roof vent circulates downward, contrary to natural convection due to the thermal effect. In our case, the ventilation rate RM (h−1) in a naturally ventilated greenhouse fits a second order polynomial with wind velocity uo (RM = 0.37 uo2 + 0.03 uo + 0.75; R2 = 0.99). The opposing wind and thermal effects mean that ventilation models based on Bernoulli’s equation must be modified in order to add or subtract their effects accordingly—Model 1, in which the flow is driven by the sum of two independent pressure fields G M 1 = | G T 2 ± G w 2 | , or Model 2, in which the flow is driven by the sum of two independent fluxes G M 2 = | G T ± G w | . A linear relationship has been obtained, which allows us to estimate the discharge coefficient of the side vents (CdVS) and roof vent (CdWR) as a function of uo [CdVS = 0.028 uo + 0.028 (R2 = 0.92); CdWR = 0.036 uo + 0.040 (R2 = 0.96)]. The wind effect coefficient Cw was determined by applying models M1 and M2 proved not to remain constant for the different experiments, but varied according to the ratio uo/∆Tio0.5 or δ [CwM1 = exp(−2.693 + 1.160/δ) (R2 = 0.94); CwM2 = exp(−2.128 + 1.264/δ) (R2 = 0.98)].