26 December 2016 in Heat and Mass Transfer
1 January 2014 in Energy Procedia
Refrigeration by vortex tube works on the principle of heat transfer between two layers moving opposite to each other. Various experiments have been performed and has revealed two different approaches one for attaining high cold mass fraction and the other for attaining cold end temperature. The geometry requirement is different for the two approaches. The need is to have a tube to produce higher mass of cold air coming out at low temperature. For this purpose converging type of vortex tube is experimented and the results are promising. The results show increase in cold mass fraction as well as cold end temperature. The overall change in cold end temperature drop was 63% and the COP of the converging tube as compared to straight divergent tube increased by 102%. For conical valve angle of 45° air supply pressure of 5 bars and cold orifice diameter as 7mm the lowest temperature observed was 5°C producing cold mass fraction of about 0.9
3 August 2017 in Heat Transfer
10 April 2024 in E3S Web of Conferences
This study focuses on the possible transformative effects that green nanotechnology has in the healthy energy applications and the repression of nature`s negative impacts. By means of environmentallyfriendly production of these nanomaterials, including silver nanoparticles (AgNPs) and quantum dots, the current research produced the marked increase in efficiency of solar cells, with a jump to 53% in efficiency compared to traditional solar cells. Moreover, the dopping of lithium-ion cells with silicon nanoparticles brought about a great enhancement, exhibiting a 50% specific capacity progress contrasted with the batteries that continued traditional anodes. Hence, these excellent findings demonstrate the effectiveness of nanotechnology in transforming energy that gathers and holds technology. The paper did an LCA that entailed a detailed analysis of the life cycle of green nanomaterials in order to measure the impact on the environment. The analysis presented by the LCA indicated the application of alternative materials that resulted in a significant reduction of GHG’s (32%), energy of 33%, and In TP of 37%) in comparison with conventional ones. This highlights the sustainability gains that will be obvious by the use of green nanotechnology as a technology of choice, in energy applications. The findings provide numerous beneficial principles for development of green technologies.
5 April 2016 in Heat and Mass Transfer
30 September 2017 in Mechanical Engineering Research
The vortex tube is an energy separation device that separates compressed gas stream into a low and a high temperature stream. Present work reports the flow behavior inside the vortex tube for different commonly used fluids with varied properties like Air, He, N2, CO2 and NH3. Flow behavior investigation for three-dimensional short straight-diverging vortex tube is done with CFD code (ANSYS 16.0). Different turbulent models, standard k-epsilon, Realizable k-epsilon and RNG k-epsilon are tested. Realizable k-epsilon model was then used for analysis. Flow behavior of gases with varied multi-atomic number is analyzed and compared with literature. The effect on temperature for N2 is found to be better, followed by He, CO2, Air and NH3. Energy separation for N2 is 46 % higher than all other gases. Energy separation and flow behavior inside vortex tube is analyzed and compared with literature.