As an important classification of photodetectors, broad spectral photodiodes are ubiquitous in the fields of industry and scientific research. Here, we reported a type of broad spectral organic–inorganic hybrid photodiodes (OIHPDs) based on planar-bulk heterojunction, which composed of 3,4,9,10-perylenetertracarboxylic dianhydride (PTCDA), copper phthalocyanine (CuPc) and fullerene (C60). In our research, the dark current of the OIHPD with 10 nm C60 film (10 nm-C60 OIHPD) was as low as 25.6 μA, which is about 63 times smaller than the dark current of the OIHPD without C60 film (C60-free OIHPD). It is considered that the significantly enhanced performance of 10 nm-C60 OIHPD is attributed to the introduction of the C60 film, which act as hole-blocking layer to reduce the dark current. And through the schematic energy level model combined with experimental measurements, the reason for the dark current change was well explained. Furthermore, the specific detectivity of 10 nm-C60 OIHPD was almost one order of magnitude larger than it of C60-free OIHPD, and a notable enhancement of over 1011 cm Hz1/2/W was obtained due to the fiercely reduced dark current. These results provide insights on how to improve the performance of organic photodiodes.
12 February 2024 in IEEE Transactions on Electron Devices
Near-infrared Organic upconversion devices (NIR OUDs), which convert incident low-energy NIR photons to high-energy visible photons, have many advantages such as simple fabrication process, low cost, flexibility, large area fabrication, and inherent pixel-less imaging, and play important roles in night vision and security applications. In general, NIR OUDs can be realized by integrating the organic NIR photosensitive layer as the sensitizer with the active layers of the normal as well as the inverted organic light-emitting diodes (OLEDs) as emitters. The devices utilizing normal phosphorescent OLEDs as emitters have been demonstrated as the most typical structure, which exhibits higher photon-to-photon conversion efficiency than other OUDs. However, there have been very few studies of NIR OUDs utilizing inverted OLEDs as emitters. In this article, NIR OUDs based on inverted phosphorescent OLEDs as emitters were investigated. NIR OUD realized by simply integrating the NIR photosensitive layer and the inverted phosphorescent OLED emitter demonstrated a relatively low photon-to-photon upconversion efficiency, ascribing to the high injection barrier of the photo-generated electrons at the interface between the NIR photosensitive layer and the inverted OLED emitter. To improve the injection efficiency of the photo-generated electrons, NIR OUDs with different connecting layers (CLs) including an ultrathin metal Mg and Li-doped electron transport layer (ETL) were fabricated and studied. By introducing the CLs, the upconversion efficiency of the devices was effectively improved. Especially for the device with Li-doped ETL as the CL, an enhanced photon-to-photon conversion efficiency of 3.52% was achieved.
8 December 2025 in Optical and Quantum Electronics