10 February 2020 in Applied Physics Letters
AlGaN films were grown on face-to-face annealed sputter-deposited AlN/sapphire (FFA Sp-AlN) templates via metalorganic vapor phase epitaxy (MOVPE), and the growth behavior of the AlGaN films was investigated. The sapphire substrates with small off-cut exhibited poor surface flatness of AlGaN grown on the FFA Sp-AlN templates owing to the formation of large hillock structures. To understand the origin of these hillock structures, the crystallinity and surface morphology of conventional fully MOVPE-grown AlN/sapphire (MOVPE-AlN) templates and the FFA Sp-AlN template were comprehensively studied. The screw- and mixed-type threading dislocation density of the FFA Sp-AlN template was estimated to be approximately 1.8 × 106 cm−2, which was two orders of magnitude lower than that of the MOVPE-AlN template. Consequently, the uniquely observed growth of the hillock structures in the FFA Sp-AlN templates was attributed to their low density of screw- and mixed-type threading dislocations. The large surface off-cut sapphire substrates suppressed the hillock structures on the FFA Sp-AlN templates. The improvement in surface flatness resulted in better optical properties of multiple quantum wells grown on the AlGaN layer. These results demonstrate a promising method for achieving highly efficient and cost effective AlGaN based deep ultraviolet light-emitting diodes.
30 January 2023 in Scientific Reports
Memristors have attracted much attention for application in neuromorphic devices and brain-inspired computing hardware. Their performance at high temperatures is required to be sufficiently reliable in neuromorphic computing, potential application to power electronics, and the aerospace industry. This work focuses on reduced gallium oxide (GaOx) as a wide bandgap memristive material that is reported to exhibit highly reliable resistive switching operation. We prepared amorphous GaOx films to fabricate Pt/GaOx/indium tin oxide memristors using pulsed laser deposition. Stable resistive switching phenomena were observed in current–voltage properties measured between 300 and 600 K. The conduction mechanism analysis revealed that the resistive switching is caused by the transition between ohmic and space charge limiting current conductions. We elucidated the importance of appropriate control of the density of oxygen vacancies to obtain a high on/off resistance ratio and distinct resistive switching at high temperatures. These results indicate that GaOx is a promising memristor material that can be stably operated even at the record-high temperature of 600 K.
1 March 2019 in Journal of Crystal Growth
14 February 2018 in Applied Physics Express
10 June 2021 in Journal of Applied Physics
The propagation behavior of threading dislocations (TDs) and the effects of Burgers vectors in hydride vapor phase epitaxy (HVPE) GaN bulk crystals generated on Na-flux-grown GaN and in a commercially available HVPE-grown GaN bulk crystal were investigated. Analyses based on chemical etching and transmission electron microscopy (TEM) revealed a close correlation between the etch pit sizes and the Burgers vector of these TDs. The existence of TDs with the unique Burgers vector b = 1m + 1c was observed for the first time ever using a large-angle convergent-beam electron diffraction technique and plan-view bright-field scanning TEM. Multi-photon excitation photoluminescence microscopy observations showed that TDs with b = 1c had a meandering morphology in contrast to the linear morphology of TDs with b = 1a, 1a + 1c, or 1m + 1c in both types of HVPE-grown GaN crystals. The inclinations of TDs with b = 1a and 1a + 1c in HVPE-grown GaN on Na-flux-grown GaN were greatly affected by large symmetrical hexagonal hillocks. The TDs with b = 1a were inclined in the slope directions of the hillock planes, while those with b = 1a + 1c were inclined in the a directions parallel or antiparallel to the a component in their Burgers vector. These inclinations were readily explained by the isotropic elastic theory of an individual TD. The hillocks were produced around pairs of parallel mixed TDs for which the a components were opposite to one another. This phenomenon was attributed to inclusions at the interface between the Na-flux-grown GaN substrate and the HVPE-grown layer. The origins of other TDs including unusual ones having b = 1m + 1c are also discussed herein.
1 April 2019 in Journal of Crystal Growth