2 July 2020 in IEEE Photonics Journal
The Faraday laser, with Faraday anomalous dispersion optical filter (FADOF) as frequency-selection element, is a natural narrow-bandwidth light source for laser physic experiments. In this work, a dual-frequency (DF) Faraday laser is demonstrated for the first time on Cs D2 line at 852 nm. The frequencies of the two modes of DF Faraday laser hinge on the peak transition frequencies of 852 nm FADOF transmittance spectrum corresponding to the ground state F = 4 and F = 3. The frequency difference between the two modes is tunable over a range of 1.4 GHz with the temperature of Cs vapor cell inside the FADOF. The linewidth of each laser mode is less than 33 kHz. Furthermore, the most probable linewidth of the beat-note spectra between the two modes is 902.95 Hz at different vapor-cell temperatures. Such a DF Faraday laser has many potential applications in atomic physics, such as sub-Doppler spectroscopy and coherent population trapping atomic clocks.
2 May 2023 in Journal of Manufacturing Processes
10 July 2018 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
Active optical clock (AOC) has the intrinsic suppression of the influence of cavity’s noise on the output frequency, giving rise to the potentially ultra-narrow linewidth. To break the cavity’s thermal noise limitation by taking full advantage of the AOC’S principle, as well as to achieve a long-term instability, we propose a scheme of cavity stabilized active optical clock (CSAOC). The system consists of two key procedures: the dual-wavelength (DW) output signals share a same cavity and work in the good and the bad cavity regime respectively. Then the good cavity signal is locked to a reference cavity by the Pound-Drever-Hall (PDH) technique to stabilize the main cavity length. By doing this the main cavity’s noise is expected to be reduced to the thermal noise floor of the reference cavity. Hence the frequency stability of the bad cavity signal will break this noise floor due to the suppression of cavity pulling effect. Experimentally we realize the dual-wavelength good-bad cavity laser system by taking the Nd: YAG 1064 nm and Cs 1470 nm transitions as good and bad cavity gain medium. The power and linewidth characteristics of the dual-wavelength (DW) output are studied. Limitation factors of the clock frequency as well as the feasibility of the PDH cavity stabilization is analyzed.
2 June 2025 in Applied Physics Letters
Chip-scale atomic clocks are critical for applications requiring compact, energy-efficient, and highly stable timing, such as GPS receivers and communication systems. Coherent population trapping (CPT)-based atomic clocks, which commonly use vertical-cavity surface-emitting lasers (VCSELs), have enabled significant miniaturization. However, their precision is limited by the broad linewidth of VCSELs. Alternative laser technologies, such as distributed Bragg reflector lasers, distributed feedback lasers, and external cavity diode lasers (ECDLs), offer potential improvements but face challenges in achieving compact size and adequate modulation bandwidth. This study presents a 795 nm chip-ECDL with a direct modulation bandwidth up to 4 GHz, specifically designed for CPT chip-scale atomic clocks. Based on the chip-ECDL, a CPT atomic clock with a compact volume of 19.4 ml and power consumption of 1.5 W has been developed. Under identical operating conditions, the CPT signal produced by the chip-ECDL exhibits a 34% reduction in linewidth and a 1.14-fold increase in contrast compared to a VCSEL-based clock. Demonstrating short-term stability better than 5×10−11τ−1/2(1 s<τ<2000 s) and reaching a best stability of 6.6×10−13 at 2000 s, this work represents the application of an ECDL in a CPT chip-scale clock, advancing the development of next-generation, high-performance chip-scale atomic clocks.
23 May 2022 in Physical Review A
A laser with superb frequency stability plays an important role in fundamental physics research and advanced technologies. Frequency references are usually utilized to stabilize the laser, such as high-finesse cavities and atomic ensembles, of which thermal atomic beams are attractive because of their balanced performance between simplicity and stability. However, due to the transverse-velocity distribution in the thermal atomic beams, most atoms (generally ) are wasted when interacting with the laser. Here, we propose a laser referenced on a version of velocity-grating Ramsey-Bordé atom interferometry with greatly improved atom utilization and thus superior laser frequency stability. Compared with a conventional atomic interferometry applied to stabilize the laser, the proposed system in principle generates optical Ramsey fringes with the amplitude enhanced by 1000-fold or more. Such a configuration has promising applications in diverse areas, including precision measurements and quantum metrology.