Wearable sweat sensors enable noninvasive real-time biochemical monitoring, holding immense potential for personalized health care applications. However, achieving prolonged and reliable sweat sampling, along with stable biochemical analysis, remains challenging due to inconsistent secretion, rapid evaporation, and the reliance on external stimulation. Here, we present BMS 3 , a bioinspired microfluidic wearable sweat sensor system designed for multiday continuous metabolic monitoring. BMS 3 integrates hierarchically graded microchannels and superhydrophobic-superhydrophilic Janus membranes, inspired by pitcher plant trichomes and lotus leaves to enable efficient low volume sweat collection, transport, and renewal. A miniaturized carbachol gel–based iontophoresis module autonomously induces localized sweat secretion. Furthermore, the microfluidic design sustains sweat sampling for over 2 days from a single iontophoresis session, eliminating the need for physical exertion. In vitro and in vivo studies in healthy participants and patients with gout demonstrate BMS 3 ’s capability for continuous metabolic monitoring. By simultaneously tracking uric acid, xanthine, and alcohol levels, it effectively differentiates normal and pathological states while delivering timely therapeutic feedback.
The quantum of research in the area of supercapacitors is typically focused on the electrode materials. As such, there are many opportunities for the optimization of the other components, such as the separators, to further increase the power, efficiency, and longevity of supercapacitors. To contribute to this field of research, we present an innovative alternative for the fabrication of separators; using polymer/ceramic composites (PCC) based on polyvinylidene fluoride (PVDF) and polypropylene (PPG) mixed with different alkaline earth metal‐based titanates (eg barium, calcium, and strontium). The PCC separators were prepared via phase inversion precipitation technique, a feasible and scalable method for the fabrication of these composites. Different additives were used to modulate the porosity and thus, improve the charge transfer rates. Then, a heating process ensured a uniform organization of the composites. Furthermore, we tested the effect of thermally annealing the ceramics on the separators’ performance. The precursor materials and the PCC's were extensively characterized by means of X‐ray diffraction (XRD) and scanning electron microscopy (SEM). The electrochemical, mechanical, and dielectric properties of the PCC's were measured and compared to common commercial separators used today. Results suggest that thermal treatment improves tensile strength of the separators by at least ca. 60% without compromising the similar electrochemical profile to the commercial separators (44.52 ± 2.82 Ω vs 67.65 ± 29.01 Ω). Lastly, all of the fabricated PCC's showed higher dielectric constants (4.52 in average for the as prepared separators and 2.99 for the heated PCC's) than the polymer based commercial separators (2.2).