Shaker Bayajid Khan

Shaker Bayajid Khan

Auto-generated profile, based on publicly available information

Shaker Bayajid Khan

Department of Applied Physics, Universidad Politécnica de Madrid, 28040 Madrid, Spain

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2013 in Journal of Spacecraft and Rockets
Verified
Journal Article
Closed access
SKShaker Bayajid Khan
Shaker Bayajid Khan
JSJuan R. Sanmartin
Juan R. Sanmartin
The current space environment, consisting of manmade debris and micrometeoroids, poses a risk to safe operations in space, and the situation is continuously deteriorating due to in-orbit debris collisions and to new satellite launches. Bare electrodynamic tethers can provide an efficient mechanism for rapid deorbiting of satellites from low Earth orbit at end of life. Because of its particular geometry (length very much larger than cross-sectional dimensions), a tether may have a relatively high risk of being severed by the single impact of small debris. The rates of fatal impact of orbital debris on round and tape tethers of equal length and mass, evaluated with an analytical approximation to debris flux modeled by NASA’s ORDEM2000, shows much higher survival probability for tapes. A comparative numerical analysis using debris flux model ORDEM2000 and ESA’s MASTER2005 validates the analytical result and shows that, for a given time in orbit, a tape has a probability of survival of about one and a half orders of magnitude higher than a round tether of equal mass and length. Because deorbiting from a given altitude is much faster for the tape due to its larger perimeter, its probability of survival in a practical sense is quite high

1 October 2015 in Advances In Space Research
Verified
Journal Article
Open access
JSJ.R. Sanmartín
J.R. Sanmartín
ASA. Sánchez-Torres
A. Sánchez-Torres
SKS.B. Khan
S.B. Khan
GSGonzalo Sánchez-Arriaga
Gonzalo Sánchez-Arriaga
MCM. Charro
M. Charro
De-orbiting satellites at end of mission would prevent generation of new space debris. A proposed de-orbit technology involves a bare conductive tape-tether, which uses neither propellant nor power supply while generating power for on-board use during de-orbiting. The present work shows how to select tape dimensions for a generic mission so as to satisfy requirements of very small tether-to-satellite mass ratio mt/MS and probability Nf of tether cut by small debris, while keeping de-orbit time tf short and product tf ×× tether length low to reduce maneuvers in avoiding collisions with large debris. Design is here discussed for particular missions (initial orbit of 720 km altitude and 63° and 92° inclinations, and 3 disparate MS values, 37.5, 375, and 3750 kg), proving it scalable. At mid-inclination and a mass-ratio of a few percent, de-orbit time takes about 2 weeks and Nf is a small fraction of 1%, with tape dimensions ranging from 1 to 6 cm, 10 to 54 μμm, and 2.8 to 8.6 km. Performance drop from middle to high inclination proved moderate: if allowing for twice as large mt/MS, increases are reduced to a factor of 4 in tf and a slight one in Nf, except for multi-ton satellites, somewhat more requiring because efficient orbital-motion-limited electron collection restricts tape-width values, resulting in tape length (slightly) increasing too

1 May 2014 in Advances In Space Research
Verified
Journal Article
Open access
SKShaker Bayajid Khan
Shaker Bayajid Khan
JSJuan R. Sanmartin
Juan R. Sanmartin
The low earth orbit (LEO) environment contains a large number of artificial debris, of which a significant portion is due to dead satellites and fragments of satellites resulted from explosions and in-orbit collisions. Deorbiting defunct satellites at the end of their life can\ud be achieved by a successful operation of an Electrodynamic Tether (EDT) system. The effectiveness of an EDT greatly depends on the survivability of the tether, which can become debris itself if cut by debris particles; a tether can be completely cut by debris having some minimal diameter. The objective of this paper is to develop an accurate model using power laws for debris-size ranges, in both ORDEM2000 and MASTER2009 debris flux models, to calculate tape tether survivability. The analytical model, which depends on tape dimensions (width, thickness) and orbital parameters (inclinations, altitudes) is then verified with fully numerical results to compare for\ud different orbit inclinations, altitudes and tape width for both ORDEM2000 and MASTER2009 flux data

1 May 2016 in Aerospace Science and Technology
Verified
Journal Article
Closed access
SKShaker Bayajid Khan
Shaker Bayajid Khan
AFA. Francesconi
A. Francesconi
CGC. Giacomuzzo
C. Giacomuzzo
ELE.C. Lorenzini
E.C. Lorenzini

1 June 2016 in Advances In Space Research
Verified
Journal Article
Open access
RGRicardo García-Pelayo
Ricardo García-Pelayo
SKShaker Bayajid Khan
Shaker Bayajid Khan
JSJuan R. Sanmartin
Juan R. Sanmartin
It has recently been shown that a thin-tape tether, as opposite to a round one, has a high probability of survival to single impacts by space debris, under a broad range of de-orbit operation conditions. The purpose of the present work is to extend that analysis to survival to multiple impacts by smaller, but more abundant, debris. The method used here consist, essentially, in separating the particles into “large” and “small” ones. The large ones are so rare that the probability of them concurring on the same spot can be neglected. The small ones are a sort of background, and it is shown that the probability of them impinging close enough to a large particle crater to cause malfunction of the tape is negligible. A particular mission is considered, de-orbiting a 3000 kg spacecraft from 800 km altitude at 90°90° inclination by means of an aluminium tape of dimensions 10,000 m × 0.06 m × (5 × 10−5) m. It is shown that the probability that this mission survives to multiple impacts is at least 0.978. The application of this method to missions of different parameters is also discus