1 October 2025 in Engineering Research Express
Due to the structural constraints of sprockets and the efficiency requirements of on-site measurements, conventional external parameter calibration methods are difficult to apply to the calibration of the sprocket hub end surface. Therefore, this paper proposes a novel external parameter calibration method based on the invariance of quadratic curves. A cylindrical object with concentric circular rings is inserted into the central hole of the sprocket, and the radii of the large and small circles on the rings, along with the radius of the sprocket hub hole, are used to derive the coefficients of the equations corresponding to the three circles. Based on these coefficients, the external parameters of the sprocket hub end surface are determined. According to the contour characteristics of the sprocket teeth, a point selection model is established to identify the highest and lowest points within the tip and root circle regions. The radial runout is then calculated as the difference in radial distances between the highest and lowest points. In the experiments, eleven sprockets of different sizes were selected as test objects, and the results obtained using the proposed method were compared with those measured by a coordinate measuring machine (CMM). The results indicate that the measurement error of the tooth root and tip circles is less than 42 μm.
25 June 2025 in Engineering Research Express
Sheet metal coverings and other complex surface components feature a variety of holes in different shapes and sizes used for positioning. However, the batch measurement of these thin-walled, complex surfaces is highly challenging due to their susceptibility to deformation and the difficulty in planning measurement paths for the targets. This paper leverages laser triangulation methods and a three-degree-of-freedom test bench to capture point clouds of sheet metal surfaces. A novel Downsampling method that preserves edge features by reducing data dimensionality was developed from these point clouds, laying the groundwork for subsequent high-precision measurements. A simulated dataset was created and four feature descriptors were developed to train a Support Vector Machine (SVM) model for hole type classification. The four types of features extracted from real data are linearly separable in space, achieving accurate classification results. The measurement model was finally validated for accuracy on real data and noise simulated data, demonstrating that the measurement error of the proposed system is approximately 0.05 mm, indicating its potential for industrial applications.