13 March 2020 in IEEE Electron Device Letters
In this study, we report a novel structure of enhancement-mode metal-insulator-semiconductor high electron mobility transistor (E-mode MIS HEMT) with p-GaN gate by gate-all-around technology. The gate-all-around structure is fabricated by depositing an insulator and gate to surround the p-GaN mesa. The p-GaN length is smaller than the gate length, which would easily turn on the two dimensional electron gas (2DEG) of channel and result in a higher drain current and thus improve the device performance. The gate-all-around p-GaN MIS HEMT has better gate control, better transconductance, and lower gate leakage current. The device exhibits a threshold voltage (Vth) of 1.5 V, a maximum transconductance (Gm.max) of 101 mS/mm, and a drain saturation current density (JDS,max) of 412 mA/mm at a gate bias (Vg) of 5 V. The most important achievement is that the gate leakage current at Vg = 5 V is only 10-8 mA/mm. Moreover, the ratio of drain current density to gate leakage current density (JDS/JGS) is 108 at Vg = 5 V. Finally, the cut-off frequency (ft) and maximum oscillation frequency (fmax) of microwave performance for this gate-all-around device with a 1 μm gate length are 6.0 and 9.8 GHz, respectively.
21 July 2015 in IEEE Electron Device Letters
Trifluoromethane-containing plasma is used to passivate the mesa surfaces and suppresses the surface leakage current of GaN p-i-n rectifiers. Reduction of surface leakage enhances the reverse blocking voltage by 25% measured at J = 1 A/cm 2 . Differential forward resistances of control samples and plasma-treated ones are 0.65 and 0.49 mΩ-cm 2 , respectively, and an excellent Baliga's figure-of-merit of more than 800 MW/cm 2 , as compared with the conventional 545 MW/cm 2 , is achieved for GaN diodes fabricated on sapphire substrates.
1 January 2019 in Journal of Vacuum Science & Technology B
In this article, the authors report the fabrication and characterization of quasi-vertical gallium nitride (GaN) p-i-n diodes grown on patterned sapphire substrates. In order to reduce diode leakage current and enhance breakdown voltage, the authors design the diodes having the structures of edge termination with a multi-mesa structure coupled with a field plate. Besides, the laser annealing is used to decrease the contact resistance and lower the forward voltage. Combining these processes, the fabricated p-i-n diodes with a 5 μm i-layer exhibit a specific on-resistance (RONA) of 0.47 mΩ cm2 and a breakdown voltage (VB) of 835 V. The corresponding Baliga’s figure of merit (VB2/RONA) is 1.48 GW/cm2, which is the highest ever reported for a GaN p-i-n diode grown on a sapphire substrate. Finally, depositing an aluminum layer onto the mesa surface can effectively block the ultraviolet emission out of the diode under forward bias.
10 April 2019 in Journal of Vacuum Science & Technology B
In this letter, the authors report the micro-opto-electro-mechanical system-based large-area tunable Fabry-Pérot filters (FPF) with an aperture size of up to 300 μm. The sputtered zinc oxide layer is used as the sacrificial layer during the releasing process. The fabricated FPFs exhibit a tuning range of 188 nm in the near-infrared wavelength range when the voltage is biased from 0 to 7.5 V. The stiffness of supporting arms of the electrostatic actuator is calculated to be 2799 N/m from the analyses of capacitance-voltage measurements. The designed FPFs can be used in shortwave infrared (SWIR) spectral analyses with suitable SWIR sensors.
13 December 2018 in IEEE Journal of the Electron Devices Society
18 August 2017 in Journal of Vacuum Science & Technology B
In this article, the authors report the fabrication and characterization of quasivertical GaN p-i-n diodes with a 3 μm I-layer grown on different sizes of patterned sapphire substrates (PSSs). The diodes were characterized by current–voltage, capacitance–voltage, and deep-level transient spectroscopy. The PIN diodes grown on the smaller-size PSS showed a reverse breakdown voltage of ∼610 V and a defect concentration of 1.0 × 1016 cm−3, both of which are superior to the corresponding measurements of ∼410 V and 1.4 × 1017 cm−3 for the diodes grown on the larger-size PSS. These results indicate that the GaN PIN diodes grown on smaller-size PSS have a better quality of epitaxial layers than those grown on larger-size PSS.