1 August 2021 in Journal of Hazardous Materials
17 May 2019 in Journal of Materials Chemistry A
Hydrothermally prepared vertical multilayer WS 2 nanosheets on the surface of few-layer MoS 2 for the ultra-sensitive NO 2 detection at room temperature.
30 January 2021 in Journal of Materials Chemistry A
A simple noncovalent chemical approach and hydrothermal method were used for effectively riveting Co3O4 nanocrystals to branched polyethylenimine (PEI) functionalized Ti3C2Tx MXene sheets to fabricate Co3O4@PEI/Ti3C2Tx MXene composites. Co3O4 nanoparticles as active center components were uniformly dispersed on Ti3C2Tx MXene with high specific surface area and abundant functional groups to form a heterogeneous structure. PEI, as a channel for electron transfer, effectively improved the interaction between Ti3C2Tx MXene and Co3O4. The diffusion capacity of NOx molecules and the electron transmission efficiency at the interface between adsorbed molecules and the surface of the material were improved, which contributed to the sensing performance of the material. Meanwhile, the highest sensing response to NOx gas was seen in the Co3O4@PEI/Ti3C2Tx MXene composites with 2.4 mg addition of Ti3C2Tx sheets (CoPM-24). CoPM-24 exhibited a response and response time of 27.9 and below 2 s for NOx gas at room temperature under humidity of 26%. Moreover, CoPM-24 also showed excellent selectivity, repeatability and a low experimental detection limit (30 ppb) for NOx gas. Thus, the Co3O4@PEI/Ti3C2Tx composites are potential high-sensitivity NOx gas sensor candidates.
1 July 2020 in Journal of Hazardous Materials
28 July 2015 in Nanoscale
Establishing heterostructures, as a good strategy to improve gas sensing performance, has been studied extensively. In this research, In2O3-composite SnO2 nanorod (ICTOs) heterostructures have been prepared via electrospinning, followed by calcination. It is found that In2O3 can improve the carrier density and oxygen deficiency of SnO2. In particular, the 3ICTO (Sn : In atom ratio of 25 : 0.3) nanorods with special particle distributions show an excellent sensing response towards different concentrations of NOx at room temperature. The highest sensing response is up to 8.98 for 100 ppm NOx with a fast response time of 4.67 s, which is over 11 times higher than that of pristine SnO2 nanorods at room temperature and the lowest detection limit is down to 0.1 ppm. More significantly, it presents good stability after 30 days for NOx of low concentration (0.1 ppm and 0.5 ppm). In addition, the rational band structure model combined with the surface depletion model which describe the NOx gas sensing mechanism of 3ICTO are presented. The 3ICTO nanorods may be promising in the application of gas sensors.
12 March 2014 in Nanoscale
3D nanoflower-like CuxO/multilayer graphene composites (CuMGCs) have been successfully synthesized as a new type of room temperature NOx gas sensor. Firstly, the expanded graphite (EG) was activated by KOH and many moderate functional groups were generated; secondly, Cu(CH3COO)2 and CTAB underwent full infusion into the interlayers of activated EG (aEG) by means of a vacuum-assisted technique and then reacted with the functional groups of aEG accompanied by the exfoliation of aEG via reflux. Eventually, the 3D nanoflower consisting of 5–9 nm CuxO nanoparticles homogeneously grow in situ on aEG. The KOH activation of EG plays a key role in the uniform formation of CuMGCs. When being used as gas sensors for detection of NOx, the CuMGCs achieved a higher response at room temperature than that of the corresponding CuxO. In detail, the CuMGCs show a higher NOx gas sensing performance with low detection limit of 97 ppb, high gas response of 95.1% and short response time of 9.6 s to 97.0 ppm NOx at room temperature. Meanwhile, the CuMGC sensor presents a favorable linearity, good selectivity and stability. The enhancement of the sensing response is mainly attributed to the improved conductivity of the CuMGCs. A series of Mott–Schottky and EIS measurements demonstrated that the CuMGCs have much higher donor densities than CuxO and can easily capture and migrate electrons from the conduction band, resulting in the enhancement of electrical conductivity.