29 September 2025 in ИЗВЕСТИЯ ВЫСШИХ УЧЕБНЫХ ЗАВЕДЕНИЙ. ЭЛЕКТРОМЕХАНИКА
P(Platov South-Russian State Polytechnic University (NPI)
Platov South-Russian State Polytechnic University (NPI)
RURostov State Transport University
Rostov State Transport University
+2
Tensioning devices used in the manufacturing process of composite materials with simultaneous impregnation are con-sidered. The choice of a structural diagram for an electrical tensioning system is substantiated. It is noted that, at pre-sent, it is most practical to design electrical tensioning systems (ETS) based on the subordinate control principle. An analysis of the feasibility of using various ETS structures revealed that four-circuit ETS tensioning systems are the most practical.
25 December 2025 in Electrotechnical Systems and Complexes
KMKonstantin A. Mikitinskiy
Konstantin A. Mikitinskiy
The paper is concerned with improving the efficiency of electrotechnical tension control systems (ETCS) used in the production of composite material products by the wet winding method. It is noted that traditional control systems have limited dynamic performance due to the inertia of mechanical components, particularly the slow movement of the dancer roller responsible for adjusting the tape tension. To overcome this limitation, a new approach is proposed, which is based on the use of active spoolers, strand holders equipped with electric drives and individual tension controllers. This design makes it possible to implement a dual-loop control structure: a “fast” loop controlling the spooler motor torque and a “slow” loop adjusting the dancer mechanism position. The paper presents the functional and structural diagrams of the proposed ETCS, which include permanent magnet synchronous motors, current, speed, tension, and position controllers, as well as a logical control unit coordinating the loops operation. Mathematical modeling and transient process analysis were performed under varying external conditions (e.g., changes in the material friction coefficient along the guiding elements). The simulation results demonstrated that the system transient response time with active spoolers is approximately 0.042 seconds, which is more than five times faster as compared to conventional control schemes. The proposed ETCS architecture ensures stable tape tension and high product quality despite variations in winding geometry and speed, confirming its promise for application in modern composite material manufacturing technologies.
28 March 2024 in Electrotechnical Systems and Complexes
30 September 2025 in Electrotechnical Systems and Complexes
KMKonstantin A. Mikitinskiy
Konstantin A. Mikitinskiy
Currently, products manufactured by the winding method are widely used in many industries due to their unique physical and mechanical properties. Due to the improvement of the winding process technology, more stringent requirements for the drives speed and their adaptability to changing operating modes began to be imposed on electrical control systems. This is possible only with the use of modern, digital controls for the winding process. At the same time, it is necessary to have information about the state of the technological process. This information is obtained by using various sensors: tension, belt speed and the length of the winding path. The information from the sensor data is sent to the drive in the form of analog signals, which must later be converted to digital form. The conversion is carried out using analog-to-digital converters. In this paper, model circuits containing time delays and level quantization in analog digital converters used in the electrical engineering system have been developed in the MatLab Simulink package. Using the developed model, the effect of the information delay time during its conversion in an analog-to-digital converter and level quantization on the drive operation was studied. During the study, the delay time varied from 0.1 to 16 ms, and the level of discreteness was from 8 to 16 bits. It is shown that when using modern analog-to-digital converters with a conversion time of 1 ms or less and a bit depth of 8 bits or more, the electrical control voltage system behavior practically does not differ from a system in which there is no level conversion and the signal conversion time is zero.