3 June 2021 in Crystal Growth & Design
Amorphous calcium phosphate (ACP) is a metastable phase in the crystallization pathway of calcium phosphates. Understanding its chemical and structural properties could provide critical insights into biomineralization mechanisms. Of particular interest is the impact of the initial Ca/P on the structure of ACP. Further, the influence of Ca/P on the size, precipitate chemistry, and transformation of ACP is crucial to understanding the metastability of amorphous phosphates. In situ pair distribution function (PDF) analysis results 5 min after mixing show that the Ca–P bonding geometry varies from predominantly monodentate, to mixed monodentate and bidentate, to predominantly bidentate as Ca/P increases from 0.2 to 5.0. This relationship is consistent across a pH range of 6–11. Samples with only monodentate Ca–P geometries transform directly to hydroxylapatite, while samples some or all bidentate geometries form brushite. Regardless of the initial ratio, the Ca/P of precipitates is close to 1.0. In situ small-angle X-ray scattering shows particle size increases with increasing Ca/P. This is the first evidence of structural variations in ACP and is directly linked to system chemistry. Synthesis of ACP with monodentate Ca–P geometries is a promising method to control the crystallization pathway to form hydroxylapatite at circumneutral pH without stabilizing ions.
23 August 2019 in Acta Crystallographica Section A Foundations and Advances
Structural investigations of amorphous and nanocrystalline phases forming in solution are historically challenging. Few methods are capable ofin situatomic structural analysis and rigorous control of the system. A mixed-flow reactor (MFR) is used for total X-ray scattering experiments to examine the short- and long-range structure of phasesin situwith pair distribution function (PDF) analysis. The adaptable experimental setup enables data collection for a range of different system chemistries, initial supersaturations and residence times. The age of the sample during analysis is controlled by adjusting the flow rate. Faster rates allow for younger samples to be examined, but if flow is too fast not enough data are acquired to average out excess signal noise. Slower flow rates form older samples, but at very slow speeds particles settle and block flow, clogging the system. Proper background collection and subtraction is critical for data optimization. Overall, this MFR method is an ideal scheme for analyzing thein situstructures of phases that form during crystal growth in solution. As a proof of concept, high-resolution total X-ray scattering data of amorphous and crystalline calcium phosphates and amorphous calcium carbonate were collected for PDF analysis.