Recent Battery Energy Storage System (BESS) failures highlight the need to detect gases from venting cells as quickly as possible, as well as the vulnerabilities in existing monitoring infrastructure that would alert the occurrence and location of cell venting [1]. Conventional detection strategies, which rely on stationary gas sensors, can fail to identify low-volume gas release from single-cell early stage (first) venting, especially in large-scale BESS that have multiple racks and modules, such as Panel A in Figure 1. Suboptimal or improper fixed sensor placement, gas transport effects (e.g., thermal buoyancy), and dilution below detection thresholds further complicate failure detection. These limitations hinder emergency responders’ ability to accurately assess explosion and/or toxicity risks. To address these challenges, we propose integrating a guided mobile gas sensing platform to complement stationary gas sensors. This system will dynamically monitor spatial and temporal gas evolution during early failure stages by deploying a robotic platform equipped with commercial sensors to detect the most commonly emitted gases (CO2, H2, CO, electrolyte vapor). The robot will patrol accessible areas or be strategically guided to areas of interest to actively sample “suspicious zones” with high concentrations of vent gases. This target navigation will be informed by advanced state-of-health (SOH) diagnostics derived from electrical and thermal measurements typically available in the Battery Management System (BMS) data. A major component of our detection algorithm is to recognize how rapidly a fault is propagating to other cells or the time elapsed from the vent initiation. To this end, we first characterize venting gases in terms of composition, quantity, temperature, and time evolution. A literature review (Figure 1, Panel B) on gas characterization was conducted, and it was found that most prior work focused on global, post-thermal runaway (TR) gas analysis. However, the combustion of vent gases during TR makes their characterization challenging, leaving first venting behavior poorly understood. To address this gap, we aim to develop a systematic way to trigger gas generation without full thermal runaway by inducing controlled overheating and arresting the heat after first venting occurs. We will apply this method to two form factors: cylindrical (2.6 Ah) and prismatic (32 Ah), focusing on LFP cells due to their widespread adoption in grid-scale BESS. After characterizing single-cell behavior, we will construct a representative BESS rack (Figure 1, Panel C) with cells inside modules to study venting propagation from vented cells to the module venting channels and to the rack headspace where the stationary sensors are typically located. Our gas characterization will then inform models and algorithms that can recognize the various stages of an evolving failure, including the location and the number of cells undergoing slow discharge, venting, and/or the propagation of thermal runaway. This will guide the robotic sensor platform to reach the appropriate venting channel, providing a faster response and better guidance for first responders. By integrating robotic mobility with diagnostic and prognostic tools, this will not only improve the detection of first venting events, but also enhance situational awareness for emergency response. It enables high-confidence localization of first venting events, estimates the scale of the fault progression, and quantifies the number of cells involved in or propagating in a thermal runaway event, providing actionable data to guide safer and more rapid containment efforts. ACKNOWLEDGEMENT This project is supported by UL Research Institutes. REFERENCES [1] Srinivasan, L., Shaw, S. and Billaut, E. (2024). Insights from EPRI’s battery energy storage systems (BESS) failure incident database: analysis of failure root cause Figure 1: A typical large-scale Battery Energy Storage System (BESS) with multiple racks and modules (Panel A), an overview of literature showing the lack of vent (pre-thermal runaway) gas characterization for LFP cells (Panel B), and a representative BESS rack with a mockup of the mobile guided gas sensing platform directed to sample from a module vent (Panel C). Figure 1