Sabrina Sami

Sabrina Sami

Auto-generated profile, based on publicly available information

Sabrina Sami

Division Thermique et Thermodynamique Solaire et Géothermie, Renewable Energy Development Center, Bouzaréah, Algeria

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2018 in Energy
Verified
Journal Article
Closed access
SSS. Sami
S. Sami
DSD. Semmar
D. Semmar
AHA. Hamid
A. Hamid
RMR. Mecheri
R. Mecheri
MYM. Yaiche
M. Yaiche

1 December 2017 in Energy Procedia
Verified
Journal Article
Open access
KKK. Kaci
K. Kaci
MMM. Merzouk
M. Merzouk
NMN. Kasbadji Merzouk
N. Kasbadji Merzouk
El ganaoui MohammedEl ganaoui Mohammed
El ganaoui Mohammed
SSS. Sami
S. Sami
RDRabah Djedjig
Rabah Djedjig

1 August 2015 in Energy Procedia
Verified
Journal Article
Open access
SSS. Sami-Mecheri
S. Sami-Mecheri
DSD. Semmar
D. Semmar
AHA. Hamid
A. Hamid
In the present article, we present a numerical simulation (winter and summer) of a low energy housing of 70 m2 surface area in Algiers region. This region is part of the climate zone, A which is characterized by a cool winter and hot and humid summer. In our simulation, we use the Pleiades and Comfie software. In Order to see the temperature variation of the comfort zone; we illustrate our simulations for two weeks, the hottest and coldest week of the year. To know the energy needs (heating and cooling) we run a simulation with the thermostat instructions (the comfort temperature must be between 20° C and 24° C).we take into account different scenarios: the occupancy, the ventilation, the occupation and the dissipated energy. Note that the external temperatures injected are measured values. We integrate also in the study a solar water heating system, the simulation is done with solo software developed by Tecsol. The results shows clearly that the comfort is attended in summer, but not quite in winter and the good efficiency of water heating installation

1 March 2015
Verified
Conference Paper
Closed access
MKMustapha Koussa
Mustapha Koussa
DSDjohra Saheb
Djohra Saheb
HBHamza Belkhamsa
Hamza Belkhamsa
MLMohamed Amine Lalaoui
Mohamed Amine Lalaoui
SHSid Ali Hakem
Sid Ali Hakem
HMHamane Mustapha
Hamane Mustapha
This work consists first to highlight the domestic water heating system transient behavior. The second is to bring out the effect of the series or parallel connection of a set of flat plate solar collectors on the performances of the solar system. Thus, modeling the retained system is based on the overall energy balance method for each component of the solar water heater while having taken the initial conditions related to the collector. This is based also on the momentum conservation equation in where are considered the singular and linear pressure drop caused by the different component constituting the hydraulic circuit of retaining configuration. The resolution of the equation system was done under MATLAB environment and the effect of the mounting configuration on solar water heating system performances and on the pressure loss in the hydraulic circuit of the solar system has been brought to light. It is observed that unlike to a parallel collectors connection, for the same number of collector mounted in series leads to increase the fluid temperature, increase the thermal loss from the solar panel and by consequent decrease the solar system efficiency. Against, this increases the total pressure drop in the hydraulic circuit of the solar system.

10 February 2020 in MATEC Web of Conferences
Verified
Journal Article
Open access
PDF file
SSSabrina Sami
Sabrina Sami
KKKarim Kaci
Karim Kaci
MEMohamed El.Ganaoui
Mohamed El.Ganaoui
LOLahoucine Ouhsaine
Lahoucine Ouhsaine
The object of the present study is the integration of a solar cooling and heating system of a residential building (4-flour) located in Blida region in Algeria. The system consists of a set of solar collectors that supply energy to a balloon through an external heat exchanger. The solar and auxiliary tanks are connected by a heat exchanger immersed in the bottom of the auxiliary tank. In the distribution loop, a recirculation can make possible to obtain the domestic hot water set point temperature. A cold production system is directly connected to the solar tank and a regulation system ensures the control of the installation. We have used the TRANSOL software under TRANSYS to calculate the heating and cooling load. Several parameters are then introduced to size and evaluate the performance of our installation. The results obtained are satisfactory .