31 August 2021 in Physical Review Letters
To date, quantum computation on real, physical devices has largely been limited to simple, time-ordered sequences of unitary operations followed by a final projective measurement. As hardware platforms for quantum computing continue to mature in size and capability, it is imperative to enable quantum circuits beyond their conventional construction. Here we break into the realm of dynamic quantum circuits on a superconducting-based quantum system. Dynamic quantum circuits not only involve the evolution of the quantum state throughout the computation but also periodic measurements of qubits midcircuit and concurrent processing of the resulting classical information on timescales shorter than the execution times of the circuits. Using noisy quantum hardware, we explore one of the most fundamental quantum algorithms, quantum phase estimation, in its adaptive version, which exploits dynamic circuits, and compare the results to a nonadaptive implementation of the same algorithm. We demonstrate that the version of real-time quantum computing with dynamic circuits can yield results comparable to an approach involving classical asynchronous postprocessing, thus opening the door to a new realm of available algorithms on real quantum systems.
14 February 2024 in PRX Quantum
Qubit control electronics composed of CMOS circuits are of critical interest for next-generation quantum computing systems. A CMOS-based application-specific integrated circuit (ASIC) fabricated in 14-nm fin field-effect transistor (FinFET) technology was used to generate and sequence qubit control wave forms and demonstrate a two-qubit cross-resonance gate between fixed-frequency transmons. The controller was thermally anchored to the K stage of a dilution refrigerator and the measured power was 23 mW per qubit under active control. The chip generated single-side banded output frequencies between 4.5 and 5.5 GHz, with a maximum power output of dBm. Randomized-benchmarking (RB) experiments revealed an average number of 1.71 instructions per Clifford (IPC) for single-qubit gates and 17.51 IPC for two-qubit gates. A single-qubit error per gate of and a two-qubit error per gate of were shown. A drive-induced rotation was observed by way of a rotary-echo experiment; this observation is consistent with the expected qubit behavior given the measured excess local-oscillator (LO) leakage from the CMOS chip. The effect of spurious drive-induced errors was numerically evaluated with a two-qubit model Hamiltonian and shown to be in good agreement with the measured RB data. The modeling results suggest that the error varies linearly with the pulse amplitude.
29 March 2023 in Research Square
Qubit control electronics composed of CMOS circuits are of critical interest for next generation quantum computing systems. A CMOS–based application specific integrated circuit (ASIC) fabricated in 14nm FinFET technology was used to generate and sequence qubit control waveforms and demonstrate a two–qubit cross resonance gate between fixed frequency transmons. The controller was thermally anchored to the T = 4K stage of a dilution refrigerator and the measured power was 23 mW per qubit under active control. The chip generated single–side banded output frequencies between 4.5 and 5.5 GHz with a maximum power output of -18 dBm. Randomized benchmarking (RB) experiments revealed an average number of 1.71 instructions per Clifford (IPC) for single–qubit gates, and 17.51 IPC for two–qubit gates. A single–qubit error per gate of є1Q=8e-4 and two–qubit error per gate of є2Q=1.4e-2 is shown. A drive–induced Z–rotation is observed by way of a rotary echo experiment; this observation is consistent with expected qubit behavior given measured excess local oscillator (LO) leakage from the CMOS chip. The effect of spurious drive induced Z–errors is numerically evaluated with a two–qubit model Hamiltonian, and shown to be in good agreement with measured RB data. The modeling results suggest the Z–error varies linearly with pulse amplitude.
3 February 2026 in IEEE Open Journal of the Solid-State Circuits Society
This paper presents design approaches for two radio frequency (RF) arbitrary waveform generators (AWGs) operating at cryogenic temperatures using FinFET CMOS technologies. The paper presents power, performance, and area trade-offs for highly scaled quantum computing systems using different types of qubits (spin and transmons). The first considered design uses a direct digital synthesis (DDS) approach to provide a wide bandwidth (1−18 GHz) control solution for spin qubits. As this design point was implemented in two technology nodes (14 nm and 7 nm CMOS), it offers a window into the benefits for this application arising from technology scaling. Furthermore, the DDS architecture offers flexibility to meet the requirements of the rapidly evolving requirements of spin qubits and naturally supports a high degree of programmability of the amplitude, phase, duration, frequency and spacing of control waveforms. The DDS-based wideband radio frequency digital to analog converter (DAC) was demonstrated operational over the full 1 to 18 GHz target operating range, providing sufficient bandwidth for control signals for state-of-the-art spin qubit platforms. The second design approach uses various techniques for highly reconfigurable, low power control waveform generation for transmon qubits using current mode analog design. This second approach, implemented using two 14nm FinFET CMOS designs, has enabled the investigation of design-driven power scaling techniques. The DDS-based single spin qubit controller consumes 40−140 mW, occupying 0.5 mm2 in a 14 nm FinFET node implementation, and 30−68 mW, occupying 0.1 mm2 in a 7 nm FinFET node. The current mode transmon qubit controller designs, both implemented in 14 nm FinFET, consume 23 mW and 12.8 mW, respectively, occupying 1.61 mm2 and 1.32 mm2 per qubit controller, respectively.
1 November 2026 in IEEE Journal of Solid-State Circuits