Fábio Assunção Rosa

Fábio Assunção Rosa

Auto-generated profile, based on publicly available information

Fábio Assunção Rosa

Centre For Innovation and Technology in Composite Materials - CITeC, Federal University of São João del Rei – UFSJ, São João del Rei, Brazil

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 October 2022 in Polymer Composites
Verified
Journal Article
Closed access
GBGuilherme Germano Braga
Guilherme Germano Braga
FRFábio Assunção Rosa
Fábio Assunção Rosa
JSJulio dos Santos
Julio dos Santos
GPGilberto Garcia del Pino
Gilberto Garcia del Pino
Tulio Hallak PanzeraTulio Hallak Panzera
Tulio Hallak Panzera
FSFabrizio Scarpa
Fabrizio Scarpa

17 April 2025 in Discover Mechanical Engineering
Verified
Journal Article
Open access
PDF file
FRFábio Assunção Rosa
Fábio Assunção Rosa
PDPâmela Maria da Costa Deveza
Pâmela Maria da Costa Deveza
PPPabllo Miguel Maia Pires
Pabllo Miguel Maia Pires
JSJulio dos Santos
Julio dos Santos
LSLeandro José da Silva
Leandro José da Silva
Tulio Hallak PanzeraTulio Hallak Panzera
Tulio Hallak Panzera
Aerostatic thrust bearings utilise air as a lubricant to support loads while minimising friction and wear. The airflow within these bearings is controlled by a restrictor, which can be constructed from various materials, including porous substances. The selection of a porous material for the restrictor is particularly influenced by factors such as permeability, stiffness, and homogeneity. This work proposes a microstructural design for air restrictors based on compacted cementitious composites. A novel cementitious composite, consisting of silicon carbide (SiC) particles and Portland cement, is fabricated through cold pressing at 10 MPa and a low water-to-cement ratio of 0.30. To evaluate the effects of SiC particle size and weight fraction on the physical and mechanical properties of the composites, a statistical design approach is employed. The response variables include apparent density, apparent porosity, oxygen permeability coefficient, compressive strength, flexural strength, and dynamic modulus. In general, a significant reduction in density, compressive strength, flexural strength, and dynamic modulus, along with an increase in porosity and oxygen permeability, is achieved by composites made with smaller SiC particles. A higher weight fraction of SiC reduces bulk density and compressive strength, while increasing porosity and oxygen permeability. Finally, composites made with 67 wt% of fine SiC particles exhibit promising characteristics for aerostatic bearings, particularly in terms of porosity and permeability.