Microstructured optical fibers (MOFs) achieve their desired performance via a pattern of holes that run trough the whole length of the fiber. The variation of the hole pattern allows the production of a variety of optical effects. However, the cross-sectional hole structure can be different from that designed in the preform, due to the combined effects of surface tension and internal pressure. The present paper focuses on the comparison between experiments and numerical calculation of a six hole-optical fiber taking into account the effects of surface tension and internal hole-pressure, since those are of essential importance during drawing. It is shown that the numerical computations deliver reliable results for practical applications and can be used as a predictive tool for fiber development, as long as the inner pressure or the temperature do not exceed too high values.
The use of high speed radial impellers is very common in fans for industrial application. It is very common also to manufacture the radial impellers for these fans with circular arc blades. The design process is also almost always based on former impeller series and experimental data available. In this work a method is presented to improve the efficiency of radial impellers with a combined analytical and numerical method. This method is based on a new extended analytical formulation of the flow in radial impellers allowing optimizing efficiency in design stage. The blade shapes are computed with an inverse method. The design is then validated by means of CFD computation. Finally a prototype was built and measurements were carried out in a test rig. It is shown also that the design method delivered very good predictions leading to an efficiency increase of 13% of efficiency and a maximum flow rate increase of 11% absolute. The design point was also met. It is also shown that the numerical computations and measurements are in good agreement. An analysis of the CFD results is also presented, giving insight in the substantial flow information inside the old and the new impeller. The method presented is a combined analytical and numerical method suited to design high efficiency radial impellers without the need of a previous impeller series or knowledge of experimental data.
20 July 2011 in International Journal of Chemical Reactor Engineering
In the field of axial flow turbomachines, the two–dimensional cascade model is often used experimentally or numerically to investigate fundamental flow characteristics and overall performance of the impeller. The core of the present work is a design method for axial fan cascades aiming to derive inversely the optimum blade shape based on the requirements of the impeller and not using any predefined airfoil profiles. While most design strategies based on the airfoil theory assume constant total pressure at all streamlines, i.e. free–vortex flow, this paper investigates the possibility of varying the total pressure along the blade and based on that, an analytical expression of the outlet blade angle is determined. When computing the blade profile at specified radius, critical parameters reflecting on the flow characteristics are observed and adjusted, i.e. sufficient lift and controlled deceleration of the flow on the contour so that the resulting profile is derived for minimum losses. The validation of this design strategy is given by the numerical results obtained when employed as an optimization tool for an industrial fan: 10–20% absolute increase in the efficiency of the optimized impeller.