Victor Sergeevich Popov

Victor Sergeevich Popov

Auto-generated profile, based on publicly available information

Victor Sergeevich Popov

Enterprise “RD&P Center “Orion”, Russian Federation State Research Center, Moscow, Russia

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 September 2011 in Chemical Vapor Deposition
Verified
Journal Article
Open access
PDF file
TSToni T. Stoycheva
Toni T. Stoycheva
SVStella Vallejos
Stella Vallejos
RPRoman G. Pavelko
Roman G. Pavelko
VPViktor S. Popov
Viktor S. Popov
VSVladimir G. Sevastyanov
Vladimir G. Sevastyanov
XCXavier Correig
Xavier Correig
In this article is a report of SnO2 deposition by aerosol‐assisted (AA)CVD from tin complexes, [Sn(18‐Cr‐6)Cl4] and [Sn(H2O)2Cl4](18‐Cr‐6). The structure and properties of the precursors, used to synthesize SnO2 layers by AACVD for the first time, are characterized with the help of X‐ray diffraction (XRD), infrared (IR), and thermogravimetric analysis (TGA). Each complex is deposited by AACVD at 250, 400, and 500 °C in a flow of N2. The resulting films are studied by XRD and atomic force microscopy (AFM). Gas‐sensing properties of the deposited layers are tested to 10 ppm NO2 in air. The maximum sensor response to the analyte is measured at 300 °C.

1 June 2017 in Russian Journal of Inorganic Chemistry
Verified
Journal Article
Closed access
PDF file
NSNikolay P. Simonenko
Nikolay P. Simonenko
ESE. P. Simonenko
E. P. Simonenko
Artem S. MokrushinArtem S. Mokrushin
Artem S. Mokrushin
VPV. S. Popov
V. S. Popov
AVA. A. Vasiliev
A. A. Vasiliev
NKN. T. Kuznetsov
N. T. Kuznetsov
The synthesis of hydrolytically active heteroligand precursors of the composition [M(O2C5H7)x(iOC5H11)y] (M = Zr4+ and Y3+) using zirconium and yttrium acetylacetonates was investigated. It was shown that the reactivity of the obtained precursors in hydrolysis and polycondensation depends on the composition of the coordination sphere. It was studied how thin films of their solutions are applied by dip coating to the surface of Al2O3 substrates with platinum interdigital electrodes and a microheater. A study was made of the effect of the crystallization conditions and thickness of the oxide coatings of the composition 8 mol % Y2O3–ZrO2 on their microstructure and sensor characteristics in oxygen detection.

9 September 2021 in Nanophotonics
Verified
Journal Article
Open access
PDF file
RGRashid A. Ganeev
Rashid A. Ganeev
VPV. S. Popov
V. S. Popov
AZA. I. Zvyagin
A. I. Zvyagin
NLN. A. Lavrentyev
N. A. Lavrentyev
AMA. E. Mirofyanchenko
A. E. Mirofyanchenko
VRV. F. Razumov
V. F. Razumov
Bismuth telluride nanoparticles (NPs) attract attention due to the growth of sensitivity of the Bi 2 Te 3 NPs‐containing registrars in the near‐ and mid‐infrared ranges. We describe the synthesis and characterization of these structures and analyze the low‐order nonlinear optical properties of the colloidal suspensions and thin films containing Bi 2 Te 3 NPs using 1064 and 532 nm, 10 ns pulses. Colloidal Bi 2 Te 3 NPs demonstrate saturable absorption and positive nonlinear refraction (saturation intensity 7 × 10 8 W cm −2 , nonlinear absorption coefficient β SA = −7 × 10 −8 cm W −1 , nonlinear refractive index γ = 9 × 10 −12 cm 2 W −1 ), while at stronger excitation by 532 nm, 10 ns pulses the reverse saturable absorption dominates over other nonlinear optical processes. We achieved significant growth of the nonlinear optical parameters of the thin films containing these NPs (film thickness l = 60 nm, β SA = −1.2 × 10 −4 cm W −1 , γ = 5 × 10 −7 cm 2 W −1 in the case of 532 nm probe radiation and β = −5 × 10 −5 cm W −1 , γ = 6 × 10 −8 cm 2 W −1 in the case of 1064 nm probe radiation) compared with colloidal Bi 2 Te 3 NPs and discuss the observed peculiarities of the nonlinear response of Bi 2 Te 3 nanostructures.

5 January 2017 in Journal of Applied Physics
Verified
Journal Article
Closed access
TYT. V. Yuryeva
T. V. Yuryeva
IAI. B. Afanasyev
I. B. Afanasyev
EME. A. Morozova
E. A. Morozova
IKI. F. Kadikova
I. F. Kadikova
VPV. S. Popov
V. S. Popov
VYV. A. Yuryev
V. A. Yuryev
Presently, deterioration of glass beads is a significant problem in conservation and restoration of beaded exhibits in museums. Glass corrosion affects nearly all kinds of beads but cloudy blue-green ones are more than others subjected to disastrous destruction. However, physical and chemical mechanisms of this phenomenon have not been understood thus far. This article presents results of a study of elemental and phase composition of glass of the blue-green beads of the 19th century obtained from exhibits kept in Russian museums. Using scanning electron microscopy, X-ray microanalysis, and X-ray powder analysis, we have detected and investigated Sb-rich microinclusions in the glass matrix of these beads and found them to be micro crystallites of KSbSiO5. These crystallites were not detected in other kinds of beads which are much less subjected to corrosion than the blue-green ones and deteriorate in a different way. We believe that individual precipitates of KSbSiO5 and especially their clusters play a major role in the blue-green bead deterioration giving rise to slow internal corrosion of the bead glass.

6 November 2017 in Dalton Transactions
Verified
Journal Article
Closed access
PDF file
Alexey MikhaylovAlexey Mikhaylov
Alexey Mikhaylov
Alexander G. MedvedevAlexander G. Medvedev
Alexander G. Medvedev
TTTatiana A. Tripol'SKaya
Tatiana A. Tripol'SKaya
VPVictor S. Popov
Victor S. Popov
Artem S. MokrushinArtem S. Mokrushin
Artem S. Mokrushin
OLOvadia Lev
Ovadia Lev
This article introduces a SnO2yolk–shell synthesis protocol based on hydrogen peroxide sol–gel processing.

18 September 2020 in Journal of Communications Technology and Electronics
Verified
Journal Article
Closed access
PDF file
VPV. P. Ponomarenko
V. P. Ponomarenko
VPV. S. Popov
V. S. Popov
SPS. V. Popov
S. V. Popov
ECE. L. Chepurnov
E. L. Chepurnov
We review the synthesis methods, crystal parameters, and band structure of two-dimensional and quasi-two-dimensional materials, including graphene; group IV‒VIII transition metal dichalcogenides; 2D binary chalcogenides \({{{\text{A}}}^{{{\text{IV}}}}}{{{\text{B}}}^{{{\text{VI}}}}}\), \({\text{A}}_{m}^{{{\text{IV}}}}{\text{B}}_{n}^{{{\text{VI}}}}\), \({{{\text{A}}}^{{{\text{III}}}}}{{{\text{B}}}^{{{\text{VI}}}}}\), \({\text{A}}_{m}^{{{\text{III}}}}{\text{B}}_{n}^{{{\text{VI}}}}\), and \({{{\text{A}}}^{{{\text{II}}}}}{{{\text{B}}}^{{{\text{VI}}}}}\) of group IV, III, and II transition metals; Ti, Zr, Hf, Bi, and Sb trichalcogenides; \({{{\text{A}}}^{{\text{V}}}}{{{\text{B}}}^{{\text{V}}}}\) (AsN, AsP, PN, SbAs, SbN, SbP) 2D materials; \({{{\text{A}}}^{{{\text{III}}}}}{\text{N}}\) (A = Al, Ga, In, B) 2D nitrides; monoatomic 2D materials (phosphorene P, plumbene Pb, stanene Sn, germanene Ge, silicene Si, antimonene Sb, arsenene As, bismuthene Bi, borophene B, and octo-nitrogene 8‑N); functionalized graphene and silicon carbide SiC; CO, GeO, and SnO 2D oxides; 2D transitional metal dioxides, Ge, and Sn; 2D trioxides MoO3 and WO3; and transition metal di- and trihalides.