Rice husk was thermally decomposed to yield powder composed of silica (SiO2). Temperatures of 700°C and 1000°C were chosen as the decomposition temperatures. X-Ray Diffraction (XRD), X-Ray Florescence (XRF), Fourier Transform Infrared (FTIR), and Field Emission Scanning Electron Microscope (FESEM) analyses were conducted on a synthetic silica powder (SS-SiO2) and the rice husk ash as for the comparative characterisation study. XRD analyses clearly indicated that the decomposed rice husk yielded silica of different nature which are Crystalline Rice Husk Silica (C-RHSiO2) and Amorphous Rice Husk Silica (A-RHSiO2). Moreover, it was found that SS-SiO2 was of Quartz phase, C-RHSiO2 was of Trydimite and Cristobalite. Through XRF detection, the highest SiO2 purity was detected in SS-SiO2 followed by C-RHSiO2 and A-RHSiO2 with purity percentages of 99.60%, 82.30% and 86.30% respectively. FTIR results clearly indicated silica (SiO2) bonding 1056, 1064, 1047, 777, 790 and 798 cm−1) increased as the crystallinity silica increased. The Cristobalite phase was detected in C-RH SiO2 at the wavelength of 620 cm−1. Morphological features as observed by FESEM analyses confirmed that, SS-SiO2 and C-RH SiO2 showed prominent coarse granular morphology.
Zeta potential analysis of stanum oxide (SnO2) aqueous suspensions (pH7 to pH11) was performed prior to the electrophoretic deposition (EPD) of SnO2. Deposition of SnO2 on porous alumina was obtained by applying the EPD technique carried out by applying voltage of 18V for duration of four minutes. It was found that the depositions SnO2 suspended at pH 7 to pH 11 were successful. The relation between the SnO2 deposition with SnO2 pH and zeta potential values was established in which increased value of pH causes decreased value of zeta potential and decreased SnO2 deposition through EPD technique.
Ceramic foam is a class of highly porous materials that are used for wide range of technological applications, specifically as absorbents and membrane for wastewater treatment process. Among the potential materials include silicon carbide (SiC), alumina (Al2O3), zirconia (ZrO2), titania (TiO2), and silica (SiO2). The review clarifies on the broad types of ceramic foam, and the common techniques of foam fabrication, such as polymeric sponge method, starch consolidation, direct foaming, and gel-casting of foam. The parameters of each fabrication techniques will be discussed crucial based on the new research findings in the field of ceramic foam.
1 February 2007 in Advances in Applied Ceramics: Structural, Functional and Bioceramics
In recent years, ceramic shell mould for investment casting process is often associated to defects due to its brittle properties. The defects would originate from cracking mechanism yielded from the ceramic brittleness. In this work, the improvement of ceramic shell mould by reinforcement technique was studied and analyzed. Rice husk consisting high percentage of silica content with the ability to withstand high temperature during casting process was studied as the reinforcing component as to impede cracking mechanism. Higher Modulus of Rupture (MOR) value of ceramic shell reinforced by rice husk fiber as compared to the non-reinforced ceramic shell MOR value was obtained. Nonetheless, presence of the fused silica phase from rice husk fiber was also found to lead the formation of a new phase of zircon (ZrSiO4). These two factors were found to influence the ceramic shell composition and indirectly enhanced the ceramic shell strength performance.