Zr–Ti–Si–N coating had high thermal stability of phase composition and remained structure state under thermal annealing temperatures reached 1180 °C in vacuum and 830 °C in air. Effect of isochronous annealing on phase composition, structure, and stress state of Zr–Ti–Si–N-ion-plasma deposited coatings (nanocomposite coatings) was reported. Below 1000 °C annealing temperature in vacuum, changing of phase composition is determined by appearing of siliconitride crystallites (β-Si3N4) with hexagonal crystalline lattice and by formation of ZrO2 oxide crystallites. Formation of the latter did not result in decay of solid solution (Zr, Ti)N but increased in it a specific content of Ti-component. Vacuum annealing increased sizes of solid solution nanocrystallites from (12 to 15) in as-deposited coatings to 25 nm after annealing temperature reached 1180 °C. One could also find macro- and microrelaxations, which were accompanied by formation of deformation defects, which values reached 15.5 vol.%. Under 530 °C annealing in vacuum or in air, nanocomposite coating hardness increased. When Ti and Si concentration increased and three phases nc-ZrN, (Zr, Ti)N-nc, and α-Si3N4 were formed, average hardness increased to 40.8±4 GPa. Annealing to 500 °C increased hardness and demonstrated lower spread in values H = 48±6 GPa and E = (456±78) GPa. Zr–Ti–Si–N coatings has high wear resistance and low friction coefficient in comparison at a temperature of 500 °C possess with coatings TiN, Ti–Si–N.
Superhard nanostructured multielement coatings based on (Ti-Hf-Zr-V-Nb)N composition have been studied before and after thermal annealing at 600°C. It has been established that capture of positrons on defects takes place at the boundaries of nanograins and on interfaces (vacancies, nanopores, triple and higher-order joints of nanograins). Three-dimensional maps of the distribution of elements in super-hard coatings have been obtained using micro-proton-beam induced X-ray emission (μ-PIXE) measurements. Analysis of the μ-PIXE elemental profiles and defect profiles (obtained using a focused positron beam) helps understanding the physical picture of processes related to the formation of interfaces and sub-boundaries in nanostructured (Ti-Hf-Zr-V-Nb)N coatings.
Hard micro- and nanostructured Ti-Hf-Si-N/NbN/Al2O3multilayer coatings on steel substrates have been obtained for the first time using various deposition technologies and characterized by a...