The new phases BaLa0.9M0.1InO3.95 (M = Ca2+, Sr2+, Ba2+) with a Ruddlesden-Popper structure were obtained. It was established that all investigated samples were capable for the water uptake from the gas phase. The ability of water incorporation was due to not only by the presence of oxygen vacancies, but also due to the presence of La-O blocks in the structure. The degree of hydration of the samples was much higher than the concentration of oxygen vacancies and the composition of the samples appear to be BaLaInO3.42(OH)1.16, BaLa0.9Ca0.1InO3.25(OH)1.4, BaLa0.9Sr0.1InO3.03(OH)1.84, BaLa0.9Ba0.1InO2.9(OH)2.1. The degree of hydration increased with an increase in the size of the dopant, i.e., with an increase in the size of the salt blocks. It was proven that doping led to the increase in the oxygen ionic conductivity. The conductivities for doped samples BaLa0.9M0.1InO3.95 were higher than for undoped composition BaLaInO4 at ~1.5 order of magnitude. The increase in the conductivity was mainly attributed to the increase of the carrier concentration as a result of the formation of oxygen vacancies during doping. The proton conductivities of doped samples increased in the order Ca2+–Sr2+–Ba2+ due to an increase in the concentration of protons. It was established that all doped samples demonstrated the dominant proton transport below 450 °C.
The hexagonal perovskite Ba5In2Al2ZrO13 and In3+-doped phase Ba5In2.1Al2Zr0.9O12.95 were prepared by the solid-state synthesis method. The introduction of indium in the Zr-sublattice was accompanied by an increase in the unit cell parameters: a = 5.967 Å, c = 24.006 Å vs. a = 5.970 Å, c = 24.011 Å for doped phase (space group of P63/mmc). Both phases were capable of incorporating water from the gas phase. The ability of water incorporation was due to the presence of oxygen deficient blocks in the structure, and due to the introduction of oxygen vacancies during doping. According to thermogravimetric (TG) measurements the compositions of the hydrated samples corresponded to Ba5In2Al2ZrO12.7(OH)0.6 and Ba5In2.1Al2Zr0.9O12.54(OH)0.82. The presence of different types of OH−-groups in the structure, which participate in different hydrogen bonds, was confirmed by infrared (IR) investigations. The measurements of bulk conductivity by the impedance spectroscopy method showed that In3+-doping led to an increase in conductivity by 0.5 order of magnitude in wet air (pH2O = 1.92·10−2 atm); in this case, the activation energies decreased from 0.27 to 0.19 eV. The conductivity−pO2 measurements showed that both the phases were dominant proton conductors at T < 500 °C in wet conditions. The composition Ba5In2.1Al2Zr0.9O12.95 exhibited a proton conductivity ~10−4 S·cm−1 at 500 °C. The analysis of partial (O2−, H+, h•) conductivities of the investigated phases has been carried out. Both phases in dry air (pH2O = 3.5·10−5 atm) showed a mixed (oxygen-ion and hole) type of conductivity. The obtained results indicated that the investigated phases of Ba5In2Al2ZrO13 and Ba5In2.1Al2Zr0.9O12.95 might be promising proton-conducting oxides in the future applications in electrochemical devices, such as solid oxide fuel cells. Further modification of the composition and search for the optimal dopant concentrations can improve the H+-conductivity.
30 May 2015 in Russian Journal of Electrochemistry
Solid-phase synthesis was used to obtain four phases from the region of cubic fluorite-type La6WO12-La10W2O21 (La5WO10.5) solid solution. The temperature dependence of conductivity was measured using the impedance spectroscopy technique in the atmosphere of dry \(\left( {P_{H_2 O} = 10^{ - 4} atm} \right)\) and humid \(\left( {P_{H_2 O} = 3 \times 10^{ - 2} atm} \right)\) air and also when \(P_{O_2 }\) was varied from 0.21 to 10−20 atm. Ionic transport numbers t (ion) are calculated (0.6 to 0.9). It was shown that the La5.6WO11.4 phase had a relatively high stability towards hydrolysis, as the value of its conductivity dropped negligibly (as compared to other studied samples) after long-term sample conditioning in a humid atmosphere. Activation energies of hole (0.85 to 0.98 eV) and proton (0.49 to 0.56 eV) conductivity were calculated. The method of thermogravimetric analysis was used to determine the phase hydration degree \(X_{H_2 O}\) in the course of cooling from 980 to 200°C at \(P_{H_2 O} = 3 \times 10^{ - 2} atm\). Hydration enthalpies ΔHhydr (52 to 67 kJ/mol) were calculated.
The work focused on the layered perovskite-related materials as the potential electrolytic components of such devices as proton conducting solid oxide fuel cells for the area of clean energy. The two-layered perovskite BaLa2In2O7 with the Ruddlesden–Popper structure was investigated as a protonic conductor for the first time. The role of increasing the amount of perovskite blocks in the layered structure on the ionic transport was investigated. It was shown that layered perovskites BaLanInnO3n+1 (n = 1, 2) demonstrate nearly pure protonic conductivity below 350 °C.