In this work, high-performance enhancement-mode (E-mode) AlGaN/GaN high electron mobility transistors (HEMTs) on Si substrate for low-voltage RF applications were demonstrated. The thin-barrier AlGaN (7 nm) and CF4-based gate recess etching were adopted to realize a positive threshold voltage of 0.13 V. Attributing to the SiN strain layer grown by low-pressure chemical vapor deposition (LPCVD), the sheet resistance of the thin-barrier AlGaN/GaN heterostructure was reduced from 410 to 280 Ω/sq. Hence, the fabricated E-mode thin-barrier AlGaN/GaN HEMTs with regrown ohmic contacts and a small source-drain distance of 850 nm exhibit a high maximum output current of ~1.4 A/mm, a low ON-resistance of 0.5 Ω⋅mm, and a low knee voltage of 1.3 V. Pulsed I–V measurement shows that a low current collapse at 20 V drain quiescent condition of 2.1% was achieved. The continuous wave power measurement of the E-mode devices at 3.6 GHz shows a very large peak power added efficiency (PAE) over 65% with drain voltage Vds from 6 to 12 V (peak PAE of 67.21% at Vds = 6 V), a high maximum output power density (3.18 W/mm at 12 V), and a linear gain (17.4 dB at 6 V and 21.09 dB at 12 V). These excellent results show that the transistor maintains a constant high PAE and linearly increased gain and output power over the drain voltage variation range, which has great potential and advantages for low-voltage applications.
In this letter, AlGaN/GaN high electron mobility transistors (HEMTs) on a 6-inch Si substrate with excellent RF performance are presented for low voltage applications. Using regrown n+-InGaN ohmic contacts by metal-organic chemical vapor deposition, the ohmic contact resistance achieves an average value of $0.08~\Omega \cdot $ mm on the whole wafer. With a gate length of 220 nm and a source-drain spacing of $2.2~\mu $ m, the device exhibits a saturation current of up to 1689 mA/mm and a peak transconductance of 436 mS/mm. Once the wafer was thinned to $100~\mu $ m, 3.6 GHz load-pull measurements for the HEMT with gate width (${W}_{\text {g}}\text {)}$ of $2\times 100~\mu $ m at low drain voltages (${V}_{\text {d}}\text {)}$ of 5-15 V indicate that the device exhibits maximum output power densities (${P}_{ {\text {out}, {max}}} )$ of 0.86-4.35 W/mm and peak power added efficiencies (PAE) of 63.96%-66.23%, which are the highest output power density and PAE from AlGaN/GaN HEMTs at the same operating voltage level in sub-6GHz. Furthermore, the HEMT with ${W}_{\text {g}}$ of $8\times 125~\mu $ m also shows high PAE of 60.4%/61.19% and ${P}_{ {\text {out}, {max}}}$ of 0.56/0.75 W/mm at ${V}_{\text {d}} =5$ /6 V. The excellent properties of these AlGaN/GaN HEMTs on Si illustrate their suitability for addressing specific RF application scenarios, including portable communication devices, wireless sensor networks and so on.
25 June 2025 in IEEE Transactions on Electron Devices
In this article, we report high-performance AlN/GaN metal–insulator–semiconductor high-electron-mobility transistors (MIS-HEMTs) fabricated on 6-in Si substrate for K-and Ka-band applications, featuring optimized Al22O3/in situ SiN stacked gate dielectric. The MIS-HEMTs featuring a gate length of 0.2 μm and a drain–source spacing of 3 μm exhibited remarkable electrical characteristics and excellent interface quality, as verified by frequency-dependent capacitance–voltage (C–V) mea-surements. Moreover, device reliability was confirmed through stress testing. Under large-signal radio frequency (RF) operation at 18 GHz, the MIS-HEMTs demonstrated power-added efficiency (PAE) exceeding 75% with drain voltage (VDS) of 8 V. While at 29 GHz and VDS = 8 V, the devices achieved a PAE of 68% accompanied by power density of 1.2 W/mm. These exceptional results demonstrate the strong potential of the Al2O3/in situ SiN/AlN/GaN MIS-HEMTs on Si for high-efficiency power amplification in K-and Ka-band communication systems.
2 August 2024 in Journal of Vacuum Science & Technology B
This work investigates the impact of various geometries, suitable for ohmic regrowth applications, on the growth rate of n+-InGaN for AlN/GaN heterojunctions. In the various regrowth regions, we modelled the n+-InGaN growth rate by taking into account the diffusion effect of the growth source on the surrounding mask, using a surface migration-induced model. Additionally, we find that the peaks of n+-InGaN at the edge of the regrowth region, when higher than the surface of the SiO2 mask, will significantly affect the diffusion of the growth source on the mask. The findings provide theoretical support for designing the growth thickness of n+-InGaN on different device structures with nonalloyed ohmic contacts via metal-organic chemical vapor deposition. Therefore, it can assist in determining the appropriate size of test structures, such as transmission line model and enhance the precision of n+ materials assessment on devices.
This paper reports on high-performance Ku-band AlGaN/GaN metal–insulator–semiconductor high electron mobility transistors (MIS-HEMTs) on a Si substrate for low-voltage applications. Benefiting from the 7 nm thin-barrier AlGaN and the high-stress low pressure chemical vapor deposition (LPCVD) SiN passivation, a high saturation current of 1.56 A/mm, a low on-resistance of 0.87 Ω mm, and a small current collapse at 20 V drain quiescent condition of 2.1% were achieved. Enabled by the ability of LPCVD-SiN to allow the devices to withstand high-temperature conditions during gate dielectric deposition and post-deposition annealing, a 7 nm plasma-enhanced atomic layer deposition SiN was employed as the gate dielectric. The MIS-HEMTs show low leakage current and a large on/off current ratio. At 18 GHz, the devices achieve a peak power-added efficiency (PAE) exceeding 60% at a low drain voltage (Vds) range of 5–12 V. A peak PAE of 65.1% (Vds = 8 V) and a maximum output power density (Pout,max) of 3.46 W/mm (Vds = 12 V) were demonstrated, which are the highest PAE and Pout,max at the same operating voltage reported by GaN HEMTs in Ku-band. These excellent results show that the MIS-HEMTs have great potential in Ku-band low-voltage applications.
1 July 2026 in IEEE Transactions on Electron Devices