23 December 2010 in Energy & Environmental Science
We study hematite (α-Fe2O3) photoelectrodes for water splitting by examining the fate of photogenerated holes. Using H2O2 as an efficient hole scavenger, we collect all holes that arrive at the electrode/electrolyte interface. This provides the ability to distinguish between and quantify bulk and surface recombination processes involved in the photoelectrochemical oxidation of water. Below 1.0 VRHE, electrolyte oxidation kinetics limits the performance but above 1.2 VRHE bulk recombination becomes the limiting factor.
1 June 2004 in Journal of Applied Physics
The effect of grain size on the sensitivity of chemoresistive nanocrystalline metal-oxide gas sensors was evaluated by calculating the effective carrier concentration as a function of the surface state density for a typical sensing material, SnO2, with different grain sizes between 5 and 80 nm. This involved numerical computation of the charge balance equation (the electroneutrality condition) using approximated analytical solutions of Poisson’s equation for small spherical crystallites. The calculations demonstrate a steep decrease in the carrier concentration when the surface state density reaches a critical value that corresponds to a condition of fully depleted grains, namely, when nearly all the electrons are trapped at the surface. Assuming that the variations in the surface state density are induced by surface interactions with ambient gas molecules, these calculations enable us to simulate the response curves of nanocrystalline gas sensors. The simulations show that the conductivity increases linearly with decreasing trapped charge densities, and that the sensitivity to the gas-induced variations in the trapped charge density is proportional to 1/D, where D is the average grain size.
28 July 2006 in Nano Letters
13 March 2017 in Nature Materials
7 July 2013 in Nature Materials
13 September 2019 in Nature Energy