30 August 2023 in Journal of Materials Research and Technology
15 January 2025 in Materials Science and Engineering: A
1 August 2024 in 3D Printing and Additive Manufacturing
Metal-based additive manufacturing (MAM) method with high freedom and special fabricate technology has presented great universality in the aerospace and biomedicine field. However, a wide range of process parameters in the MAM method challenge the experimental study on the formation and evolution of defects. The numerical simulation presents its excellent accuracy and economy in predicting the evolution of multiphysics phenomena and was hence widely applied. In the current review, the available MAM methods with the fundamental phenomena were reviewed. Based on scales, numerical approaches divided into three categories were discussed and focused on their main prediction objectives and strengths or weaknesses of all the scales. To display the prediction results closer to real physical phenomena, advanced multiscale models coupled with various single-scale models are provided. The high prediction accuracy and computational efficiency enable better parameter control and defect avoidance. As a supplement and development to the physical-driven model, the data-driven model provides a new perspective on MAM methods. Based on the database generated by the physical-driven model and experiment, the data-driven models without calibration of input parameters are shown. In addition, this review discussed the development direction of numerical simulation, aiming to provide a reference for technical research in this field.
4 January 2023 in Research Square
In the direct energy deposition (DED) process, the highly energetic laser, rapid melting, and solidification processes lead to complex heat transfer and flow phenomena. A three-dimensional finite element model (FEM) is established to study the effect of process parameters on the melt pool and solidification quality during the DED process. The heat transfer, fluid flow, and solidification in the DED process of the GH3536 superalloy are studied. By investigating the effects of laser power, scanning speed, and feed rate on the morphology of melt pool and interlayer fusion, the appropriate input parameters for GH3536 are obtained. Temperature gradient and solidification rate obtained in transient thermal distribution are applied to predict the quality and morphology of the solidified structure at the cut-off point. Results show that high laser power and low scanning speed or feed rate will enlarge the melt pool. Well-solidified microstructure frequently appears in the middle of the parameter set; focusing on the enlargement of the melt pool is not the best strategy. The correlation between feed rate and laser power is not obvious. The minimum threshold for scanning speed is found at a given feed rate. When the scanning rate is below the threshold, abnormal morphology of the melt pool and irregular solidification structures will occur. The laser power and scanning speed range suitable for the GH3536 superalloy are summarized, and the undesirable and possibly fluctuating parameters are marked. The middle part of the parameter set is recommended for the feed rate.