14 November 2017 in IEEE Access
2-D printed electronics have been the focus of intense research for the past two decades primarily focused on implementing electrical interconnect by dispensing conductive binder-based inks. More recently, traditional printed electronics processes have been leveraged within 3-D printed structures where components and interconnect are introduced during fabrication interruptions. The dielectric performance of 3-D printed materials compares well with traditional printed circuit board (PCB) dielectrics but one remaining challenge is the low conductivity of printed ink traces. The performance degradation is due to curing temperature limits imposed by the properties of the polymer substrates. Thermoplastics, such as ULTEM, can maintain form at over 200 °C, but production ink curing processes require 850 °C to provide an appropriate conductivity. Previous reports have described submerging wires with selective energy within a thermoplastic substrate upon which 3-D printing can continue uninhibited. As copper wires have the same conductivity as PCBs and can be implemented in a wide range of cross-sectional areas, 3-D printed electronics are now in a position to transform the electronics industry. This paper describes an inter-layer process to insert metal connection between layers-allowing for improved routing density and leveraging the geometries brought to bear by 3-D printing. Minimum placement distance between these 3-D printed vias was initially 1.5 mm, and the vias can connect layers separated by as much as 2.8 mm in the vertical build direction (z-axis). As the number of wires layers that can be fabricated is not as limited as traditional board lamination, complex routing can be realized within mass customized, arbitrary shapes.
12 April 2021 in International Journal of Precision Engineering and Manufacturing
18 July 2018 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Build defects, such as nozzle clogging and thermal substrate deformation, are common in material extrusion additive manufacturing technologies, and are difficult to detect because of the high-temperature environment of fused deposition modeling (FDM) machines that do not accommodate internal sensors. To overcome this difficulty, this paper integrated an external sensor to monitor the supply current of the motor that fed filament into an extrusion head. This paper describes the investigation of the relationship between the deposition status and the reaction torque on the filament-feed motor. A dynamic model of the internal operation of the FDM extrusion head was developed and used to infer printing defects. The change in reaction force opposing extrusion was indirectly measured by monitoring the current delivered to the filament-feed motor, and consequently, the use of other sensors in the high-temperature chamber was avoided. An analysis of the supply current, in both time and frequency domains, enabled the detection of defects during material deposition.
31 August 2020 in Journal of the Korean Society of Manufacturing Process Engineers