High‐speed impact ejecta at velocities comparable to the impact velocity are expected to contribute to material transport between planetary bodies and deposition of ejecta far from the impact crater. We investigated the behavior of high‐speed ejecta produced at angles of 45° and 90°, using both experimental and numerical methods. The experimental system developed at the Planetary Exploration Research Center of Chiba Institute of Technology (Japan) allowed us to observe the initial growth of the ejecta. We succeeded in imaging high‐speed ejecta at 0.2 μs intervals for impacts of polycarbonate projectiles of 4.8 mm diameter onto a polycarbonate plate at an impact velocity of ~4 km s−1. Smoothed particle hydrodynamics (SPH) simulations of various numerical resolutions were conducted for the same impact conditions as pertaining to the experiments. We compared the morphology and velocities of the ejecta for the experiments and simulations, and we confirmed a close match for high‐resolution simulations (with ≥106 SPH particles representing the projectile). According to the ejecta velocity distributions obtained from our high‐resolution simulations, the ejection velocities of the high‐speed ejecta for oblique impacts are much greater than those for vertical impacts. The translational motion of penetrating projectiles parallel to the target surface in oblique impacts could cause long‐term, sustained acceleration at the root of the ejecta.
31 May 2023 in Journal of Geophysical Research: Planets
Knowledge of the shock behavior of planetary materials is essential to interpret shock metamorphism documented in rocks at hypervelocity impact structures on Earth, in meteorites, and in samples retrieved in space missions. Although our understanding of shock metamorphism has improved considerably within the last decades, the effects of friction and plastic deformation on shock metamorphism of complex, polycrystalline, non‐porous rocks are poorly constrained. Here, we report on shock‐recovery experiments in which natural granite was dynamically compressed to 0.5–18 GPa by singular, hemispherically decaying shock fronts. We then combine petrographic observations of shocked samples that retained their pre‐impact stratigraphy with distributions of peak pressures, temperatures, and volumetric strain rates obtained from numerical modeling to systematically investigate progressive shock metamorphism of granite. We find that the progressive shock metamorphism of granite observed here is mainly consistent with current classification schemes. However, we also find that intense shear deformation during shock compression and release causes the formation of highly localized melt veins at peak pressures as low as 6 GPa, which is an order of magnitude lower than currently thought. We also find that melt veins formed in quartz grains compressed to >10–12 GPa contain the high‐pressure silica polymorph stishovite. Our results illustrate the significance of shear and plastic deformation during hypervelocity impact and bear on our understanding of how melt veins containing high‐pressure polymorphs form in moderately shocked terrestrial impactites or meteorites.
Dry lakebeds might constitute large volatile reservoirs on Mars. Hypervelocity impacts onto ancient dry lakebeds would have affected the volatile distribution on Mars. We developed a new experimental method to investigate the response of evaporitic minerals (halite and gypsum) to impact shocks in an open system. This technique does not result in chemical contamination from the operation of the gas gun. The technique is termed the “two‐valve method,” and the gun system is located in the Planetary Exploration Research Center, Chiba Institute of Technology, Japan. We detected the vaporization of halite at 31 GPa and devolatilization from gypsum at 11 GPa, suggesting that impact‐induced volatile release from dry lakebeds has periodically occurred throughout Martian history. The vaporization of halite deposits might have enhanced the production of perchlorates, which are found globally on Mars. The water loss from gypsum possibly explains the coexisting types of Ca‐sulfates found in Gale Crater.
Shocked meteorites can be used to probe the dynamics of the early Solar system. Carbonaceous chondrites are less shocked than ordinary chondrites, regardless of the degree of aqueous alteration. Here, we show that this shock metamorphic dichotomy is a consequence of impact-driven oxidation of organics that are abundant in carbonaceous but not ordinary chondrites. Impact experiments at 3–7 km s−1 using analogs of chondrite matrices reveal evidence of local heating in the matrix up to ~2000 K. Impacts on carbonaceous asteroids cause explosive release of CO and/or CO2, which can efficiently remove evidence of shock. We show that highly shocked materials are lost to space from typical-sized chondrite parent bodies (~100 km in diameter), but are retained on the largest known carbonaceous asteroid, namely, (1) Ceres, due to its stronger gravity. Ceres’ surface is thus a witness plate for the ancient impact environment of carbonaceous chondrite parent bodies.
The tensile strength of solid particles is the key parameter that controls not only the formation of planetesimals in protoplanetary disks but also outburst and splitting of comets and rotational bursting of asteroids in planetary systems. It is, therefore, highly desirable to find a mathematical model that properly provides the tensile strength of porous and nonporous solid particles as functions of their known material and structural properties. We demonstrate the applicability of a rigorous theory for the tensile strength of particle assemblies to both porous and nonporous solid particles, by treating the particles as solid media with cross-linked networks of molecules. The practicability of the analytical function for the tensile strength of solid particles provided in this paper is proven to a large extent by the reproduction of laboratory experiments and molecular dynamics simulations of water ice, silica, and carbon specimens, irrespective of their crystallinities. While there is still room for improvement, specifically, on the choice of material-dependent parameters, we may conclude that our formulation is a major step forward in the inference of small-bodies’ material and structural properties from observational data on their tensile strengths.
Mechanical properties of small bodies such as dust, pebbles, and planetesimals are key to better understanding the formation of planetary systems against their collisional destruction. We present a simple mathematical formulation to determine the static tensile strength, elastic modulus, fracture energy, fracture toughness, and sound velocity for solid particles of any composition, size, structure, and porosity. This formulation is based on the Johnson–Kendall–Roberts theory of contact mechanics, the Griffith theory of fracture mechanics, and the Weibull theory of flaw statistics, in which both aggregate particles and monolithic particles are treated as agglomerates of small constituent grains and molecules, respectively. We show that our formulae are consistent with the results of laboratory experiments and molecular dynamics simulations for porous and nonporous particles of silica or ice, irrespective of the sintering process and the internal heterogeneity. This provides us with a great opportunity to infer the internal structure of asteroids and comets from observational data on their tensile strengths.