A poly(glycerol monomethacrylate) (PGMA) macromolecular chain transfer agent has been utilized to polymerize benzyl methacrylate (BzMA) via reversible addition–fragmentation chain transfer (RAFT)-mediated aqueous emulsion polymerization. This formulation leads to the efficient formation of spherical diblock copolymer nanoparticles at up to 50% solids. The degree of polymerization (DP) of the core-forming PBzMA block has been systematically varied to control the mean particle diameter from 20 to 193 nm. Conversions of more than 99% were achieved for PGMA51–PBzMA250 within 6 h at 70 °C using macro-CTA/initiator molar ratios ranging from 3.0 to 10.0. DMF GPC analyses confirmed that relatively low polydispersities (Mw/Mn < 1.30) and high blocking efficiencies could be achieved. These spherical nanoparticles are stable to both freeze–thaw cycles and the presence of added salt (up to 0.25 M MgSO4). Three sets of PGMA51–PBzMAx spherical nanoparticles have been used to prepare stable Pickering emulsions at various copolymer concentrations in four model oils: sunflower oil, n-dodecane, n-hexane, and isopropyl myristate. A reduction in mean droplet diameter was observed via laser diffraction on increasing the nanoparticle concentration. Finally, the cis diol functionality on the PGMA stabilizer chains has been exploited to demonstrate the selective adsorption of PGMA51–PBzMA100 nanoparticles onto a micropatterned phenylboronic acid-functionalized planar surface. Formation of a cyclic boronate ester at pH 10 causes strong selective binding of the nanoparticles via the cis-diol groups in the PGMA stabilizer chains, as judged by AFM studies. Control experiments confirmed that minimal selective nanoparticle binding occurred at pH 4, or if the PGMA51 stabilizer block was replaced with a poly(ethylene glycol) PEG113 stabilizer block.
2 June 2014 in Journal of the American Chemical Society
A new cysteine-based methacrylic monomer (CysMA) was conveniently synthesized via selective thia-Michael addition of a commercially available methacrylate-acrylate precursor in aqueous solution without recourse to protecting group chemistry. Poly(cysteine methacrylate) (PCysMA) brushes were grown from the surface of silicon wafers by atom-transfer radical polymerization. Brush thicknesses of ca. 27 nm were achieved within 270 min at 20 °C. Each CysMA residue comprises a primary amine and a carboxylic acid. Surface zeta potential and atomic force microscopy (AFM) studies of the pH-responsive PCysMA brushes confirm that they are highly extended either below pH 2 or above pH 9.5, since they possess either cationic or anionic character, respectively. At intermediate pH, PCysMA brushes are zwitterionic. At physiological pH, they exhibit excellent resistance to biofouling and negligible cytotoxicity. PCysMA brushes undergo photodegradation: AFM topographical imaging indicates significant mass loss from the brush layer, while XPS studies confirm that exposure to UV radiation produces surface aldehyde sites that can be subsequently derivatized with amines. UV exposure using a photomask yielded sharp, well-defined micropatterned PCysMA brushes functionalized with aldehyde groups that enable conjugation to green fluorescent protein (GFP). Nanopatterned PCysMA brushes were obtained using interference lithography, and confocal microscopy again confirmed the selective conjugation of GFP. Finally, PCysMA undergoes complex base-catalyzed degradation in alkaline solution, leading to the elimination of several small molecules. However, good long-term chemical stability was observed when PCysMA brushes were immersed in aqueous solution at physiological pH.
12 October 2001 in Journal of Biomedical Materials Research