16 December 2023 in Geochimica et Cosmochimica Acta
15 October 2021 in Contributions to Mineralogy and Petrology
Raman spectroscopy has been widely used in mineralogy and petrology for identifying mineral phases. Some recent applications of Raman spectroscopy involve measuring the residual pressure of mineral inclusions, such as quartz inclusions in garnet host, to recover the entrapment pressure condition during metamorphism. The crystallographic orientations of entrapped inclusions and host are important to know for the modelling of their elastic interaction. However, the analysis of tiny entrapped mineral inclusions using EBSD technique requires time consuming polishing. The crystallographic orientations can be measured using polarized Raman spectroscopy, as the intensities of Raman bands depend on the mutual orientation between the polarization direction of the laser and the crystallographic orientation of the crystal. In this study, the Raman polarizability tensor of quartz is first obtained and is used to fit arbitrary orientations of quartz grains. We have implemented two rotation methods: (1) sample rotation method, where the sample is rotated on a rotation stage, and (2) polarizer rotation method, where the polarization directions of the incident laser and the scattered Raman signal are parallel and can be rotated using a circular polarizer. The precision of the measured crystallographic orientation is systematically studied and is shown to be ca. 0.25 degrees using quartz wafers and quartz plates that are cut along known orientations. It is shown that the orientation of tiny mineral inclusions (ca. 2–5 μm) can be precisely determined and yield consistent results with EBSD.
29 October 2019 in Contributions to Mineralogy and Petrology
26 February 2025 in European Journal of Mineralogy
Tungsten (W) concentrations in fluids in equilibrium with crystalline tungsten oxide are used to determine thermodynamic parameters for W solubility and W species in hydrothermal fluids. The solubility data were measured in situ at high pressures and temperatures using X-ray absorption. X-ray spectroscopic data measured in situ – with X-ray absorption near-edge structure (XANES) and extended X-ray absorption fine structure (EXAFS) – were applied to characterize the symmetry and the type of atoms of the first coordination shell of W aqueous complexes present in the fluid at given temperatures and pressures. Experiments were performed at up to 400 °C and at pressures of 40, 50 and 60 MPa. With this dataset, we were able to improve constraints for the already-suggested fluid species WO , HWO , H2WO , NaWO and NaHWO . Further, we were able to introduce the H3WO species that is found to be dominant in acidic fluids. No evidence was found for W species involving Cl− as a ligand. The ionic W species found in the fluid are characterized by a tetrahedral complex at alkaline conditions. In neutral to acidic conditions, W complexes with distorted octahedral symmetry are formed. These complexes may be polymerized at temperatures ≤200 °C and W concentrations mol kg−1 H2O. X-ray spectroscopy as well as thermodynamic modeling suggests that polytungstate species are not relevant at equilibrium concentrations found in the solubility experiments of this study ( mol W kg−1 H2O in equilibrium with tungsten oxide) or at concentrations reported for natural systems. Using the thermodynamic properties of the species mentioned above, in situ data on the solubility of scheelite can be successfully described. Thermodynamic modeling shows that scheelite solubility and wolframite solubility strongly increase with increasing salinity, especially up to 1 m NaCl (m denotes molality), and vary with pH, which is consistent with earlier reports. Overall, this study provides improved thermodynamic properties for a set of W fluid species that cover a wide range of fluid compositions, which is necessary for understanding the complex processes of W enrichment and mineralization in hydrothermal systems.
25 October 2022 in European Journal of Mineralogy
The mutual influence of F and OH groups in neighboring sites in topaz (Al2SiO4(F,OH)2) was investigated using magic angle spinning nuclear magnetic resonance (MAS NMR) and Raman spectroscopy. The splitting of 19F and 1H NMR signals, as well as the OH Raman band, provides evidence for hydrogen bond formation within the crystal structure. Depending on whether a given OH group has another OH group or fluoride as its neighbor, two different hydrogen bond constellations may form: either OH⋯O⋯HO or F⋯H⋯O. The proton accepting oxygen was determined to be part of the SiO4 tetrahedron using 29Si MAS NMR. Comparison of the MAS NMR data between an OH-bearing and an OH-free topaz sample confirms that the 19F signal at −130 ppm stems from F− ions that take part in H⋯F bonds with a distance of ∼ 2.4 Å, whereas the main signal at −135 ppm belongs to fluoride ions with no immediate OH group neighbors. The Raman OH sub-band at 3644 cm−1 stems from OH groups neighboring other OH groups, whereas the sub-band at 3650 cm−1 stems from OH groups with fluoride neighbors, which are affected by H⋯F bridging. The integrated intensities of these two sub-bands do not conform to the expected ratios based on probabilistic calculations from the total OH concentration. This can be explained by (1) a difference in the polarizability of the OH bond between the different hydrogen bond constellations or (2) partial order or unmixing of F and OH, or a combination of both. This has implications for the quantitative interpretation of Raman data on OH bonds in general and their potential use as a probe for structural (dis-)order. No indication of tetrahedrally coordinated Al was found with 27Al MAS NMR, suggesting that the investigated samples likely have nearly ideal ratios, making them potentially useful as high-density electron microprobe reference materials for Al and Si, as well as for F.
14 December 2023 in European Journal of Mineralogy
The Western Gneiss Region (WGR) in western Norway exposes ultrahigh-pressure (UHP) eclogites that occur repeatedly, within an area of high-pressure (HP) eclogites, without evidence of being separated by tectonic shear or ductile flow structures. We studied 10 eclogites from two northern UHP areas and the interjacent HP area to evaluate the significance of this pattern. The orthopyroxene in orthopyroxene-bearing samples has low Al2O3 contents (0.17 wt %–0.37 wt %), provided its grain boundaries were unaffected by partial recrystallisation or replacement. Classical geothermobarometry based on element partitioning between coexisting mineral phases suggests metamorphic conditions within the diamond stability field for the samples from both the HP and UHP areas. The primary clinopyroxene in the associated orthopyroxene-free eclogites contains aligned inclusions of either needle-shaped quartz ± pargasite or lamellar albite, which are absent from the secondary (symplectic) clinopyroxene. Reconstructed mineral compositions of the primary clinopyroxene obtained from grain cross-section surfaces using a scanning electron beam or image processing are non-stoichiometric, and they have higher Ca-Eskola and lower Ca-Tschermak components than the inclusion-bearing host clinopyroxene. The molar ratios of these endmembers are consistent with the needles in the primary clinopyroxene being formed from vacancy-bearing precursor clinopyroxene by the exsolution reaction 2 Ca-Eskola = Ca-Tschermak + 3 quartz during early eclogite-facies retrogression. Further retrogression partially transformed the needle-shaped quartz to irregularly shaped albite within the clinopyroxene and partially transformed both clinopyroxene generations to amphibole that occasionally preserves the needles. The similarity of both the maximum metamorphic conditions and the mineral exsolution microstructures in the eclogites from UHP and HP areas indicates a shared metamorphic history within the stability field of diamond, but a history that diverged during retrogression. Consequently, the alternations of UHP and HP areas in the WGR may have formed by a process that allowed for spatial variations in retrogression efficiency, such as the localisation of strain (recrystallisation) or fluid flow (diffusion) or both, rather than by tectonic stacking of UHP and HP units. Evidence for the UHP metamorphism of WGR crustal rocks is now found from NE to SW along the entire coastal section that covers previously recognised UHP and interjacent areas.