15 April 2000 in Physical Review B
Quantitative measurements of frequency shift vs distance curves of ultrahigh-vacuum force microscopy in a noncontact mode are presented. Different contributions from electrostatic, van der Waals, and chemical interactions are determined by a systematic procedure. First, long-range electrostatic interactions are eliminated by compensating for the contact potential difference between the probing tip and the sample. Second, the long-range van der Waals contribution is determined by fitting the data for distances between 1 and 6 nm. Third, the van der Waals part is subtracted from the interaction curves. The remaining part corresponds to the short-range chemical interaction, and is found to decrease exponentially. A Morse potential is used to fit these data. The determined parameters indicate that the interaction potential between single atoms can be measured by force microscopy in a noncontact mode.
15 July 2000 in Physical Review B
Atomically resolved dynamic force microscopy (DFM) images of step and kink sites of NaCl films grown on the Cu(111) surface are presented. Combining experimental results with an atomistic modeling of DFM imaging, we study the mechanism of contrast formation and extract more information about the tip and NaCl film structure. The experimental results and theoretical modeling systematically demonstrate the enhanced interaction of step and kink sites of one kind with the tip. This is explained by the enhanced gradient of the electrostatic potential at low-coordinated surface sites, and considerable displacements of the step edge and kink atoms from their sites due to the interaction with the tip upon approach. The theoretical analysis predicts that the silicon tip is effectively an insulator, and that the NaCl island cannot be thicker than two monolayers. We discuss the shape and chemical structure of the tip and the mechanism of damping during DFM imaging.
14 February 2003 in Physical Review Letters
Using a noncontact atomic-force and scanning-tunneling microscope in ultrahigh vacuum, we have measured the switching energy of a single molecule switch based on the rotation of a di-butyl-phenyl leg in a Cu-tetra-3,5 di-tertiary-butyl-phenyl porphyrin. The mechanics and intramolecular conformation of the switched leg is controlled by the tip apex of the noncontact atomic-force microscope. The comparison between experimental and calculated force curves shows that the rotation of the leg requires an energy less than , which is 4 orders of magnitude lower than state-of-the-art transistors.
15 October 1999 in Physical Review B
Friction force microscopy experiments in ultrahigh vacuum allow the observation of atomic-scale stick-slip processes on Cu(111) surfaces. The lateral stiffness of the contact and the electrical characteristic of the junction are discussed. It is suggested that the tip is covered by copper forming a contact of a few atoms with the Cu(111) surface. The mean friction exhibits a clear dependence on the scan velocity.
1 September 1999 in Surface Science
15 November 2000 in Physical Review B
Experimental aspects of measuring dissipation on atomic scale using large-amplitude dynamic force microscopy are discussed. Dissipation versus distance curves reveal that long- and short-range forces contribute to the dissipation. The decay length of short-range contributions is found to be close to that of the tunneling current. The dependence of dissipation on the bias voltage and on the oscillation amplitude is presented. Atomic-scale lateral variations of dissipation are discussed, and the role of the atomic constitution of the tip for quantitative results is pointed out.