A broadband dual-polarized notched-band antenna is proposed for the application of 2/3/4/5G base stations. The radiator of the antenna is composed of a pair of crossed printed dipoles, and is fed by both broadband baluns. Based on the broadband dual-polarized antenna with a tooth-shaped slot line in the baluns, a crossed dumbbell-shaped parasitic element is proposed above the radiator to generate a notch band from 2.9 to 3.1 GHz, while improve the impedance matching in the operating band (1.71 - 2.69 GHz & 3.4 - 3.6 GHz). To verify the principle, the antenna was fabricated and measured. The experimental results confirm that it achieves a bandwidth covering 1.71 - 3.6 GHz (VSWR < 1.5) with a notch band. The measured isolation is > 35 dB in the operating band. The antenna has a half-power beamwidth (HPBW) within 69.5 ± 4° and gain within 8.1 ± 0.4 dBi in the 2/3/4G bands, and a gain within 6.6 ± 0.5 dBi in the 5G band.
25 January 2023 in IEEE Transactions on Antennas and Propagation
As a new type of super-low frequency (SLF, 30~300Hz) magnetic antenna, the permanent magnetic mechanical antenna (PMMA) has great potential for applications in underwater communication, underground communication, and earthquake prediction. PMMAs use large volume permanent magnets to enhance the signal, posing a significant challenge to power consumption of the mechanical drive structure. We optimize the permanent magnets in terms of magnetization structure, magnetic material, and form factor to determine the optimal permanent magnet structure. We establish an analytical model of the magnetic torque of the array elements and the radiated field of the array to determine the optimal array form. Based on the analytical model, we analyze the effects of the array element spacing, the phase difference of the array elements and the number of array elements on the radiated time-varying magnetic field. Finally, a 3D array prototype operating in frequency band of 75Hz~125Hz is developed for testing. The test results show that when the phase difference is less than 26°, the effect on the radiation intensity of the array is negligible. When the array element spacing is 0.15m, the motor cannot drive the mechanical structure, and when the array element spacing increases to 0.3m, it can operate normally. Communication experiments were conducted and the transmission rate could reach 2bps.
19 April 2024 in IEEE Transactions on Antennas and Propagation
In this paper, a double-lossy-layer frequency-selective rasorber (FSR) with an ultrawide reflection suppression band is presented based on the equivalent circuit approach with a clear, concise, and effective design process. First, the general equivalent circuit model (ECM) of double-lossy-layer FSRs is established and studied to reveal the mechanism of the operation band extension of the absorption-transmission (A-T) FSRs to the lower frequency. Second, a single-polarized FSR is designed inversely based on the optimized circuit parameters to fulfill the ideal desired performances. The evolution process is exhibited step-by-step and the equivalent-circuit-based design guideline is summarized. Simulation results show the single-polarized FSR achieves a low reflection band (|S 11 | ≤ -10 dB) from 1.07 GHz to 12.66 GHz, with a ratio bandwidth of 11.83:1. The 80% absorption band covers 0.99-7.11 GHz (151.1%) and the -1-dB transmission bandwidth is 43.0%, ranging from 7.97 GHz to 12.33 GHz. Then, a dual-polarized FSR is further presented and optimized to preserve excellent frequency responses. In addition, the proposed FSR also achieves ultra-miniaturization and thus improves angular stability partly. Finally, a dual-polarized FSR prototype of 20 × 20 unit cells is fabricated and measured to verify the design and the measurement results coincide well with the simulation ones.
4 October 2022 in IEEE Transactions on Antennas and Propagation
Common-mode resonance in traditional tightly coupled arrays (TCAs) limits bandwidth severely. In this communication, a common-mode resonance suppressing surface (CRSS) is proposed to mitigate the common-mode resonance. The CRSS is a surface etched with slots along the polarized direction placed below the antenna array to replace the ground of traditional TCAs. The CRSS cuts off the surface current on the ground, and thus the common-mode resonance is mitigated. Furthermore, a dual-linear polarized TCA embedded with the CRSS is simulated and manufactured, and the results show that it achieves an impedance bandwidth of 9.3:1 (0.6-5.58 GHz) and more than 90% radiation efficiency for broadside with the active VSWR≤3.0. Besides, such array remains the same bandwidth while scanning up to 60° in E-plane and D-plane and scanning up to 45° in H-plane with the active VSWR≤3.5. Therefore, the CRSS shows very promising application in engineering.
Ultrawideband phased antenna array has been widely used in communications, radars and detection. However, the high profile and poor wide-angle scanning characteristics have always been the critical limitation for many available ultrawideband antenna applications. In this paper, an ultra-thin loading window (UTLW) is proposed to replace the wide-angle impedance matching (WAIM) superstrate in the planar ultrawideband modular antenna arrays (PUMA), and reduces the profile height greatly. The UTLW consists of two strips in parallel, and each strip is loaded with one resistor and two capacitors. Following the equivalent circuit model (ECM) of the PUMA, the resistance and capacitance are specially designed to make the complex impedance of the UTLW equal to the impedance introduced by the WAIM. A dual-polarized PUMA with an UTLW achieves 6-18 GHz impedance bandwidth with active VSWR ${\mathbf \le }~2.6$ for scanning up to 60° and active VSWR ${\mathbf \le }~3$ for scanning up to 70° in E/D/H plane. The profile height of the proposed PUMA is only less than $0.07\boldsymbol {\lambda _{l}}$ , or, $0.24\boldsymbol {\lambda _{h}}$ with reference to the typical Nyquist half-wavelength spacing frequency. A $20\,\,\bf {\mathbf \times }\,\,20$ prototype PUMA with the UTLW was fabricated and its measured results were found consistent with the simulation results.