4 February 2021 in IEEE Transactions on Industry Applications
This study proposes a new technique using multisynchrosqueezing transform (MSST) for subsynchronous oscillation (SSO) detection and modal parameter identification. First, MSST is used to process the real-time data of voltage or current collected by the phasor measurement unit (PMU) to obtain the time–frequency spectrum representation of the signal. Nonzero MSST coefficients are used to represent the frequency components of the original signal at each time. Then, for the unknown number of subsynchronous frequency range components, the mean-shift algorithm is applied to the nonzero MSST coefficients to determine the number of SSO modes contained in the signal and the mode type to which nonzero MSST coefficients belong. Subsequently, the corresponding MSST coefficients of each mode exceeding the threshold are used to reconstruct the components of the original signal. Finally, the least-squares estimation method is used on the reconstructed signal to obtain the parameters of each mode, such as amplitude, phase angle, and damping factor. Through simulation case studies and comparison with existing methods, it is verified that the proposed method utilizes the abundant information contained in the PMU data and demonstrates superiority and effectiveness in multimodal signal time–frequency analysis. Moreover, practical issues and potential applications of this technique are systematically discussed.
10 February 2022 in IEEE Transactions on Industry Applications
With a high proportion of new energy and power electronic equipment connected to the modern power system, a new type of subsynchronous oscillation (SSO) is triggered, which affects the safe and stable operation of the system. Accurate analysis and identification of the SSO source becomes the key to studying this problem. This article presents a novel method to analyze SSOs. First, multisynchrosqueezing transform is applied to the signal to get the concentrated time–frequency analysis results. Then, the ridge tracking method is utilized to identify and reconstruct the subsynchronous component signals. The method of dissipating energy flow is applied to locate the source and sink of the SSO in the subsynchronous component signals. The performances of the proposed method are verified using electromagnetic transient simulations in a three-wind farms system and a modified IEEE 10-generator 39-bus New England power system.
1 March 2006 in International Journal of Bifurcation and Chaos