Laboratory of Thermal and Renewable Energy, Department of Physics, Unit of Training and Research in Pure and Applied Sciences, University Joseph Ki-Zerbo, Ouagadougou, Burkina Faso
Auto-generated profile, based on publicly available information
Issa Zerbo
Laboratory of Thermal and Renewable Energy, Department of Physics, Unit of Training and Research in Pure and Applied Sciences, University Joseph Ki-Zerbo, Ouagadougou, Burkina Faso
Aside from the terrestrial magnetic field that is generated from the earth core, power transmission, and distribution lines, transformers and other equipment do produce a certain amount of magnetic field that could interfere with the performance of photovoltaic modules. This study conducted an experiment and investigated the performance of a silicon photovoltaic module subjected to a magnetic field. The current-voltage and power-voltage characteristics were plotted in the same axis system and allowed us to find, as a function of the magnetic field, the electrical parameters of the photovoltaic module such as maximum electric power, fill factor, conversion efficiency, and charge resistance at the maximum power point. These electrical parameters were then used to calculate the series and shunt resistances of the equivalent circuit of the photovoltaic module. The results have shown that the efficiency of a solar module is affected by the presence of magnetic fields. However, the magnitude of ambient magnetic field generated by power transmissions lines and other equipment is extremely low (in the order of 10−2 mT or less) as compared to the values of the magnetic field used in this study. That made it difficult to conclude as to the impact of such field on solar photovoltaic installations.
7 April 2021 in International Journal of Photoenergy
Investigating the Effect of Inclination Angle of Magnetic Field Vector on Silicon PV Modules: In earlier studies, we have shown theoretically and experimentally that magnetic fields (MFs) have negative impact on silicon PV module (photovoltaic module). A noticeable decline in photocurrent with a slight increase in photovoltage was observed. Also, how those fields affected other key module’s parameters was also studied. These studies concluded that an increase in the magnitude of the MF resulted in the decrease of the efficiency of the silicon PV module. The previous experimental studies assumed that the MF vector formed zero angle of inclination with respect to the photosensitive face of the module. They did not factor in any effect that could be observed when the field vector is inclined. The present experimental work is an attempt to fill that gap. The characteristic curves of the PV module were plotted in the same system of axis for different values of the inclination angle of the MF vector. Correspondingly, the characteristic values (, , , , and ) of the PV module were also determined. These parameters then allowed the calculation of the efficiency of the module, its fill factor, and the equivalent circuit series and shunt resistances. It is observed that the module efficiency increases with the inclination of the MF vector, indicating that the effect of the MF on the PV module is reduced when its vector aligns towards a direction that is perpendicular to the base of the module. For example, when moves from 0 to 90°, the power output and consequently the efficiency of the PV module relatively increase of 14%.
29 December 2019 in International Journal of Photoenergy
The aim of this work is to study the behaviour of a silicon solar cell under the irradiation of different fluences of high-energy proton radiation (10 MeV) and under constant multispectral illumination. Many theoretical et experimental studies of the effect of irradiation (proton, gamma, electron, etc.) on solar cells have been carried out. These studies point out the effect of irradiation on the behaviour of the solar cell electrical parameters but do not explain the causes of these effects. In our study, we explain fundamentally the causes of the effects of the irradiation on the solar cells. Taking into account the empirical formula of diffusion length under the effect of high-energy particle irradiation, we established new expressions of continuity equation, photocurrent density, photovoltage, and dynamic junction velocity. Based on these equations, we studied the behaviour of some electronic and electrical parameters under proton radiation. Theoretical results showed that the defects created by the irradiation change the carrier distribution and the carrier dynamic in the bulk of the base and then influence the solar cell electrical parameters (short-circuit current, open-circuit voltage, conversion efficiency). It appears also in this study that, at low fluence, junction dynamic velocity decreases due to the presence of tunnel defects. Obtained results could lead to improve the quality of the junction of a silicon solar cell.
1 January 2020 in Advances in Materials Science and Engineering
This paper investigated, by one‐dimensional modelling, the effects of reverse polarisation of an electromagnetic field, generated by an amplitude modulation radio antenna, on the efficiency of a silicon PV cell. Through a simulation, the effects of both the incidence angle and the electromagnetic field magnitude on the power output of the PV cell are analyzed. The power output curves against the junction dynamic velocity are used to find the junction dynamic velocity at the equilibrium, the maximum power output, and the efficiency of the PV cell. The results have shown that the presence of important electromagnetic fields in the neighborhood of a silicon PV cell decreases its performance.
30 January 2020 in International Journal of Antennas and Propagation
The increasing cohabitation between telecommunication antennas generating electromagnetic waves and solar panels poses the problem of interaction between these radio waves and solar cells. In order to study the effect of radio waves on the performance of a polycrystalline silicon solar cell in a three-dimensional approach, it is necessary to assess the attenuation of the radio wave in the illuminated polysilicon grain and also to find the expressions of its components. This work investigated the attenuation of radio waves into a polycrystalline silicon grain by analyzing, firstly, the behaviour of the penetration length of the radio waves into the polysilicon grain and secondly, the behaviour of the attenuation factor. The propagation of the radio waves into the polycrystalline silicon grain can be considered without attenuation that can be neglected.
1 October 2026 in World Journal of Advanced Research and Reviews
The objective of this study is to design an optimal photovoltaic (PV) pumping irrigation system for agricultural production. The selected site is located in the municipality of Komsilga, Burkina Faso. The field to be irrigated covers an area of 51,116.3 m². Based on a reference evapotranspiration of 6.5 mm/day, representing the worst-case scenario, a total daily water requirement of 318 m³ was established. Three boreholes were drilled to meet this daily water demand. A water tower with a capacity of 106 m³ was constructed for each borehole. A preliminary study estimated the borehole depth at 60 m with a diameter of 50 cm. A total dynamic head (TDH) of 165 m was determined through simulation using PVsyst software. For practical and techno-economic reasons, we opted for a "run-of-sun" photovoltaic pumping system. To optimize pumping, we used crop coefficients corresponding to the mid-season growth stage and selected the potential evapotranspiration rate for March, 6.5 L/m²/day, as the design basis. Three three-phase electric pumps, each with a power rating of 16 kW and a nominal voltage of 400 V, were sized and selected for this application. They will operate from 9:00 AM to 3:00 PM, with peak pumping occurring at 12:00 PM. Subsequently, the photovoltaic solar array was sized. To meet the requirements, a PV array consisting of 162 monocrystalline silicon modules, capable of delivering a peak power of 81 kWp, was selected based on sizing calculations. To power the AC electric pumps, three 40 kVA inverters were sized and chosen.