This work presents a thermodynamic analysis of a triple-level pressure combined power plant with supplementary firing. The supplementary firing is a technological development for improving and increasing the output power of a combined-cycle (CC) power plant. In Mexico, there is a plant operating with this configuration, which generates a net power of 1,170 MW, with a power ratio of the gas turbine (GT) to the steam turbine (ST) of 1.35∶1. This plant is composed of four combined-cycle units with supplementary firing, each providing an output power of 292.5 MW. The energetic and exergetic analyses of the combined cycle with and without supplementary firing are pursued, taking into account the combustion process of natural gas and humid air. These analyses are also carried out for the heat recovery steam generator, considering the waste gases of the gas turbine and of the supplementary firing as the energy sources. The obtained results are fuel, steam, and humid air flows; excess of air; gas and stea...
19 September 2018 in Journal of Applied Polymer Science
In this work the thermodynamic analysis of two power cycles operating at ultracritical and supercritical conditions (300 bar, 600°C), and conventional or subcritical (124 bar, 538°C) is made. The supercritical cycle has ten and eight stages of regenerative feed heating. The conventional cycle has seven and six stages of regenerative feed heating. The aim of this analysis is to show the variation of work out, thermal efficiency, the heat rate, specific steam and fuel consumptions and the operating range of the pressure of overheating. For example, supercritical conditions operation of 300 bar and 600°C and a condensation pressure of 0.1107 bar, the maximum pressure reheating is 100 bar, because with a higher pressure, steam quality at the end of the step of expanding the low pressure turbine will be less than 0.88, requiring a second reheating. Additionally, the supercritical Rankine cycles have better thermal efficiency than subcritical cycles, increases in average 6%, and consequently the heat rate and steam and fuel consumption decrease.
En este trabajo se presenta el análisis termodinámico de las centrales geotérmicas con configuraciones de vapor seco, cámaras flash y ciclos híbridos en función de las condiciones del recurso geotérmico y la presión de la primera cámara flash, considerando la calidad del vapor de la última etapa de expansión como restricción límite de operación; se obtienen las curvas de trabajo de las turbinas de vapor y los perfiles de temperatura del ciclo binario. Para las configuraciones con vapor húmedo, el arreglo con tres cámaras flash presenta la mayor eficiencia térmica, exergética y de trabajo de las turbinas de vapor, por ejemplo para una temperatura de 200°C, el máximo trabajo generado es de 80.11 kJ/kg con una presión de la primera cámara flash de 6.0 bar, la eficiencia térmica y exergética de 10.7% y 44.0% respectivamente, esto se debe principalmente al aprovechamiento del aumento de la entalpía y exergía del vapor.
En este trabajo se presenta el análisis energético y exergético de las centrales de generación de potencia que utilizan las configuraciones de ciclos de vapor ultracríticos, supercríticos, subcríticos regenerativos y los sistemas geotérmicos con dos y tres cámaras flash. Este análisis se realiza principalmente a las turbinas de vapor para analizar la transformación y la degradación de la energía en cada una de las etapas de expansión en función del grado de recalentamiento y de las irreversibilidades generadas. En las etapas de expansión de presión intermedia que se realizan después del primer y segundo recalentamiento se tienen las eficiencias exergéticas más altas. Sin embargo, para el caso del ciclo supercrítico, la máxima eficiencia se tiene en la segunda etapa de expansión de la sección de alta presión. Las menores eficiencias se tienen en los sistemas geotérmicos debido a su condición de baja entalpía, aunque la disponibilidad de la energía se aprovecha en 42%.