Apesar do desenvolvimento das tecnologias voltadas para a construção civil, um dos maiores obstáculos a ser superado são as patologias das edificações. Essa problemática atinge principalmente o desempenho e a vida útil das construções, e ocorre devido à redução de prazos, projetos inadequados, uso inadequado dos materiais, falta de manutenção, mão de obra desqualificada e ausência de fiscalização. Portanto, o presente artigo fez uma análise de um imóvel composto por uma estrutura em concreto pré-moldado na cidade de Bom Conselho-PE. O principal objetivo desse trabalho foi identificar e caracterizar as principais manifestações patológicas nos elementos estruturais da construção. A metodologia aplicada para a identificação das patologias consiste em vistorias, exames, análises e interpretações. Além disso também foram utilizados ensaios não destrutivos através de testes de esclerometria, com o objetivo de verificar a dureza superficial do concreto, fornecendo elementos para a avaliação da qualidade do concreto endurecido e estimativa de sua resistência à compressão. Os resultados permitiram detectar os problemas existentes, sendo possível identificar deformações em 81% das vigas, 33% dos pilares apresentando falhas e 78% das lajes com fissuras. Dessa forma, foi possível estabelecer as orientações técnicas necessárias para o reparo e manutenção da edificação.
The partial replacement of cement by mineral additions such as metakaolin has been widely applied in the production of high-strength and durable concretes due to the pozzolanic action, allowing a reduction in the consumption of cement. Tests are performed to determine the mechanical properties of these materials, such as compressive strength, for which there are different levelling techniques of specimens, such as sulphur and neoprene, indicated for different resistance classes. The present study aimed to characterize the behaviour, in the hardened state, of concrete produced with high initial strength Portland cement (CPV-ARI) and metakaolin and evaluate the different levelling methods. Three groups of samples dosed by the IPT-EPUSP method, with mix designs of 1:3, 1:5, and 1:6, and replacements of 8 and 10% of cement by metakaolin, were subjected to compressive strength test, at the ages of 28 days, with levelling by neoprene, and 90 days, with levelling by sulphur. It was observed an increase in strength with addition of metakaolin at both ages. Comparing the results in the two ages, it was verified an increase in strength for the mix designs 1:5 and 1:6 and a reduction for the mix design 1:3. Such fact can be explained by the high strengths achieved by this mix design. As the levelling method used was sulphur, it is confirmed the imprecision of results for strengths above 50 MPa with this technique.
25 April 2021 in Research, Society and Development
The search for methods that provide savings greatly drives the search for alternatives when it comes to cost reduction. The obsession with aesthetics and cheaper alternatives for civil construction, can lead to unexpected and dangerous results. The reduction of the dimensions of the columns can be done consciously, always keeping in mind the compliance with normative standards combined with structural optimization. The objective of this work was to evaluate the efforts resulting from the reduction of the minimum dimensions beyond that established by NBR 6118 (ABNT, 2014) and compare with the considerations of NBR 15575 (ABNT, 2013) about a possible permission to reduce the minimum dimensions of columns. For this, the software MathCAD, Eberick and SAP2000 were used to implement the calculation and design methods of the columns. The variables evaluated were the steel area of columns with different cross sections, length of buckling and the necessary anchoring length that a beam would need to anchor in the columns. As a result, it was found that in relation to the steel area, the decrease in the section resulted in increases in the steel area. The buckling was not acceptable (λ> 140) with a cross-section column less than 19 cm for situations of double height up to 6 m in height, according to NBR 15575 cites. The criterion of anchoring the beam reinforcement in a column with section smaller than 14 cm was not feasible for all situations.
25 April 2021 in Research, Society and Development
Even though we know that the construction industry is constantly evolving, due to the emergence of construction techniques and materials, we note that there are still challenges to be faced: pathological manifestations. These, in turn, compromise the performance and useful life of the elements. Its occurrences are mainly due to the reduction of deadlines, inadequate design solutions, improper use of materials, unskilled labor, lack of maintenance, lack of inspection, among other aspects. The evaluation of a structural element is based on the precedence of guaranteeing durability and quality to ensure the integrity of users. Therefore, this article analyzed structural elements of a reinforced concrete bridge located in the city of Correntes-PE. The main objective of the work was to characterize the main pathological manifestations affecting the structural elements of the bridge. The process of characterization of degrading agents was carried out through non-destructive tests, such as the carbonation front, as provided for in EN 14630 (DIN, 2007) and the evaluation of surface resistance, through the sclerometry test, according to NBR 7584 (ABNT, 2012). The results allowed to characterize the strength of the concrete and the degree of degradation. Points with incidence of carbonation and exposed reinforcement were identified, denoting the need for preventive and corrective intervention, in order to prolong the useful life and performance of the evaluated artwork.
10 June 2026 in Architecture, Structures and Construction
O desempenho funcional e a salubridade da edificação são elementos fundamentais na construção civil, garantindo a ausência de patologias que interfiram no seu desempenho. As edificações devem apresentar conforto e segurança para as pessoas que nela habitam. Estre trabalho teve como objetivo verificar as conformidades técnicas, funcionais e de manutenção dos componentes construtivos de uma edificação multifamiliar, na cidade de Garanhuns, Pernambuco, Brasil. O foco foi definir um diagnóstico das manifestações patológicas e suas causas, de acordo com a norma de inspeção predial nacional, pelas recomendações OP-003-2015 e pelas NBR 13752 (ABNT, 1996); NBR 6118 (ABNT, 2014); NBR 15775 (ABNT, 2013); NBR 7200 (ABNT, 19980); NBR 13281 (ABNT, 2005) e NBR 7584 (ABNT, 2012). Na metodologia, foi usada a pesquisa bibliográfica, pesquisa exploratória e estudo de caso. Os dados obtidos foram submetidos a abrangência de investigação, credibilidade e ajustes de informações com base na qualidade técnica das análises, a inspeção predial realizada foi de nível 1. O estudo foi elaborado com base no embasamento da análise de riscos associado ao uso e exposição ambiental. Os resultados encontrados permitiram a caracterização das conformidades técnicas e do desempenho em serviço do imóvel, destacando para problemas de ordem elétrica e estrutural como principais problemas a serem reparados.