Temperature dependence of DC conductivity σDC(T) of spin-coated poly (3,4 ethylenedioxythiophene): poly(4-styrenesulfonate) (PEDOT:PSS) films has been studied. σDC(T) was measured in films deposited from mixtures of PEDOT/PSS: H 2 O (1:0.5), PEDOT:PSS (without dilution), PEDOT/PSS: Isopropyl Alcohol (IPA) (1:0.5) and PEDOT/PSS:IPA (1:1). Room temperature conductivity σ RT of PEDOT/PSS films is enhanced from 4.46×10 -5 S/cm to 6.07×10 -4 S/cm after dilutions with H 2 O and IPA (1:1), respectively. Experimental data is fitted with two different transport models: thermal activated conduction and variable range hopping (VRH) model. It is found that σ DC (T) of PEDOT/PSS:IPA (1:1) sample can be described by the one-dimensional (1D) VRH model with an pre-exponential factor σ 0 =28.5 S/cm and material-dependent parameter T 0 =39,204 K.
Inorganic-organic hybrid solar cells with different frontal interface configurations have been studied. Spin-coated conducting polymer Poly (3,4 ethylenedioxythiophene): poly(4-styrenesulfonate) (PEDOT:PSS) or boron doped a-Si:H films were used as p-type layer. Intrinsic amorphous silicon (a-Si:H) films and P3HT:PCBM heterojunctions were investigated as absorbing layers. Solar cell performance was characterized by current-voltage measurements under AM1.5 illumination and spectral measurements in the range from hν = 1.5 to 3.5 eV. The stack structure with a-Si:H (absorbing layer)/PEDOT:PSS (p-layer) interface exhibited the highest short circuit current density (J sc ). The best open circuit voltage (V oc ) as a large as 0.73 V was observed in the stack structure with a-Si:H/P3HT:PCBM heterojunction as absorbing layer. Finally, in the spectral response of hybrid configurations is possible to distinguish the J sc contributions of both organic and inorganic layers.
In this work we study the influence of hydrogen dilution on morphological properties and electronic of SiGe:H films. Surface morphology measured by Atomic Force Microscopy (AFM) technique and temperature dependence of conductivity, together with conductivity measurements in dark and under AM1.5 illumination at room temperature were used for characterization. Dark conductivity and Fermi energy varied from 10 -8 Ω -1 cm -1 to 10 -4 Ω -1 cm -1 and from 0.45 to 0.08 eV, respectively, with changing hydrogen dilution from R H =9 to.80.
In this work we study the atomic composition in SiGe:H films as a function of hydrogen dilution. Silane and germane fluxes are kept constant while hydrogen flow is varying to achieve dilutions up to 80 times. Solid content of principle elements as well as contaminants are determined by SIMS. For low dilutions (from 9 to 30), germanium solid content strongly depends on hydrogen dilution since it varies from 0.485 to 0.675. Higher presence of hydrogen in the mixture does not change germanium content which remains close to the value of 0.69.
Measurements of non-steady-state P-EMF current as a function temporal and spatial modulation frequencies were performed on intrinsic hydrogenated amorphous silicon film at 633 nm wavelength. The experimental behavior of photo-EMF current is well described by a bipolar photoconductivity model. Material photoelectric parameters such as majority carriers' lifetime, dielectric relaxation time, electron and holes diffusion lengths and their mobility-lifetime products were estimated from the experimental data.